V6 Engine Change Ignition Coils Specs Specifications

1998-2007 Toyota Land Cruiser FJ100 Specifications

Look up Toyota Land Cruiser FJ100 specification, engine oil capacity, spark plug gap, safety rating, fuel consumption, transmission, and light bulb sizes.


  • Type: J100

Engine 2.7L 4-Cylinder DOHC

  • Recommended Oil viscosity: 5W-20
  • Recommended Engine Oil: API
  • Drain Plug Torque:  30FT-LBS
  • Oil capacity: 7.0 qt

Spark Plug Gap

  • 2.7L 4-Cylinder: 0.044”

Engine 3.5L 6-Cylinder DOHC

  • Recommended Oil viscosity: 0W-20
  • Recommended Engine Oil: API
  • Oil capacity: 5.8 qt

Spark Plug Gap

  • 3.5L 6-Cylinder: 0.044”


  • Capacity: 96 L (25.4 gal., 21.1 Imp. gal.)

Cooling System

  • Type:
    • “Toyota Super Long Life Coolant” is used in your Toyota vehicle at factory fill. To avoid technical problems, use “Toyota Super Long Life Coolant” or similar high-quality ethylene glycol-based non−silicate, non−amine, non−nitrite, and non−borate coolant with long−life hybrid organic acid technology. (Coolant with long−life hybrid organic acid technology is a combination of low phosphates and organic acids.) Do not use plain water alone. Please contact your Toyota dealer for further details.
  • Capacity:
    • Without rear heater: 14.7 L (15.5 qt, 12.9 Imp. qt.)
    • With rear heater: 15.4 L. (16.3 qt, 13.6 Imp. qt.)

Automatic Transmission

  • Type: 
    • Toyota Genuine ATF WS
    • Change automatic transmission fluid only as necessary. Generally, it is necessary to change automatic transmission fluid only if your vehicle is driven under one of the Special Operating Conditions listed in your “Scheduled Maintenance Guide” or “Owner’s Manual Supplement.” When changing the automatic transmission fluid, use only “Toyota Genuine ATF WS” (ATF JWS3324 or NWS9638) to ensure maximum transmission performance. Notice: Using automatic transmission fluid other than “Toyota Genuine ATF WS” may cause deterioration in shift quality, locking up of your transmission accompanied by vibration, and ultimately damage your vehicle’s automatic transmission.
  • Capacity: 3.0 L (3.2 qt, 2.6 Imp. qt.)


  • Type: Gear oil API GL−4 or GL−5  (SAE 75W−90)
  • Capacity:  1.3 L (1.4 qt, 1.1 Imp. qt.)

Chassis Lubrication

  • Type:
    • Wheel bearings: Lithium base wheel bearing grease, NLGI No.2
    • Front drive shaft thrust bushings: Synthetic oil and lithium soap base chassis grease, NLGI No.1
    • Propeller shafts (Spiders): Lithium base chassis grease, NLGI No.2
    • Slide yoke: Lithium base chassis grease, NLGI No.2 or Molybdenum—disulfide lithium base chassis grease, NLGI No.2
  • Capacity: 
    • Front: 1.6 L (1.7 qt, 1.4 Imp. qt.)
    • Rear: 3.3 L (3.5 qt, 2.9 Imp. qt.)


  • Type: SAE J1703 or FMVSS No.116 DOT 3


  • Type: Automatic transmission fluid DEXRON II or III


  • Type: Suspension fluid AHC



  •  Petrol:
    • 4.5 L 1FZ-FE I6
    • 4.7 L 2UZ-FE V8
  • Diesel:
    • 4.2 L 1HZ I6
    • 4.2 L 1HD-T turbocharged I6
    • 4.2 L 1HD-FTE turbocharged I6


  • 4-speed automatic
  • 5-speed automatic
  • 5-speed manual

Fuel Consumption



  • Rushit Hila • ASE Certified

    Rushit Hila, an ASE-certified engineer (G1 Automotive Maintenance and Repair), brings over two decades of hands-on experience in the automotive world to his writing. With a strong educational background, including a Master of Science in Engineering and a Bachelor of Science in Engineering, he has honed his skills and expertise through years of practical work. As a respected authority in the field, Mr. Hila is dedicated to offering insightful and valuable content that resonates with both vehicle owners and mechanics.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *