How to Change Front Brake Pads on Mitsubishi Outlander

DIY Cost: $30-$55
Est. Time: 1 hr
Difficulty: Easy
This guide provides instructions on how to replace front brake pads on Mitsubishi Outlander. 

What you will need


  1. Start by putting your Mitsubishi Outlander in the park and setting the emergency brakes. Next, loosen the lug nuts but don't remove them.
  2. Jack up your Mitsubishi Outlander. Secure the car with jack stands.
  3. Remove the front wheel from the car.
  4. Use a flathead screwdriver to put pressure between the old pad and caliper. This will press the piston into the brake caliper, which is required to fit in the new brake pads.
  5. Use a 14mm socket to remove one of the guide pins.
  6. Fold out the brake caliper and remove the old brake pads and shims.
  7. Install the new brake pads. Apply a small amount of grease where the brake pads slide on the brake caliper. Do not apply brake grease on the brake pad surface or brake rotor.
  8. Install the brake caliper. Apply grease to the guide pins.
  9. Torque guide pins to 31 Nm or 23 ft-lb.
  10. Install the wheel and tighten the lug nuts. Remember to torque the lug nuts when the vehicle has been lowered.
  11. Start your engine and pump the brake pedal a few times before you start to drive.

That's it. You have successfully changed front brake pads on a Mitsubishi Outlander.

How much does it cost to change brake pads on a Mitsubishi? 

The average cost to replace the brake pads on a Mitsubishi Outlander is $195-$300 if you are replacing only the brake pads. If you replace the rotors at the same time that price goes up to $450-$600. 

If you decide to replace your Mitsubishi brake pads and rotors yourself, you will spend $100-$150 on parts. 

Was this helpful?
We would love to hear from you. Send us tips on how to improve this article.
Send us message if you have any car questions.

Check out more guides for the following vehicle.
How to Change Front Brake Pads on Mitsubishi Outlander What you will need Mitsubishi Outlander Front Brake Pads Jack and Jack Stands Flathead screwdriver 14mm socket