In this guide, you will find step-by-step instructions on how to change window switch on Hyundai Elantra  2011-16

Owners of Hyundai Accent, Santa Fe, Sonata, Veloster, Kona, Azera may also find these instructions helpful.

What you will need

Procedure

  1. Park your vehicle and set the parking brakes. 

  2. Remove the door panel. The panel is held in place with two screws. One on the center of the door panel and the second by the door handle. 

  3. Once the two screws are removed you can pull out the door panel. Make sure to disconnect all the wires before you pull the panel out.
  4. Remove old window switch from the driver's door panel. To remove the window switch you will need to use a flat screwdriver to release the switch from the housing. There are no screws for the window switch.window switch hyundai elantra 2011 2012 2013 2014 2015 2016

  5. Now you should be able to remove the window switch from the door panel.hyundai elatra door switch replacement diy guide
  6. Install new window switch. Press it in place until it all the tabs lock-in. Make sure to reconnect the electrical connector. Reinstall the door panel in reverse order.
  7. Make sure to slide it at the channel near the glass.how to replace window switch hyundai elantra
  8. Next, install the door panel.  If you need further information on how to replace the Hyundai window switch take a look at the shop manual. 

 

 

Comments

Visitor
Member since 2020-05

I was quoted $420 for diagnosis and replacement of the window switch. After watching this I went ahead and replaced it myself. New used switch cost me just $35. :) Keep up the great work. You saved me $400.

  •  
  •  
  •