Is your Kia / Hyundai refusing to accelerate when you press the gas pedal?
In this article, we will discuss common problems that can cause Kia and Hyundai vehicles to not accelerate. In one situation a Kia was only accelerating to about 15 mph and would not go any faster than that.
Kia or Hyundai vehicles may fail to accelerate due to problems with the throttle position switch. When the driver presses the gas pedal the maximum speed that car be reached is about 10 or 15 mph. Some symptoms include that the engine has no power when you press the gas pedal or that the RPMs will not go past 2000.
The first warning that you may get is the check engine light will come on. Soon after you may notice that the engine or vehicle speed does not increase when you press the gas pedal. It is common as well for this issue to be intermittent at the early stages.
It is easy to misdiagnose this problem as an engine misfire. Thus changing the spark plugs is not going to solve the problem if the issues are caused by a faulty throttle position sensor. You may also wonder if the car is out of gas. That's why it is important to read the CEL
The most common issues that will make your vehicle not accelerate is a faulty throttle position switch also referred to as the TPS. The Throttle Position Sensor is a potentiometer that controls the throttle valve. Check with the dealer to see if they have an updated position switch.
Replacing the TPS at the dealership can cost around $400-$600 USD depending on your location and model. Replacement TPS for Kia and Hyundai can also be purchased on eBay, here is a TPS listing for Kia/Hyundai.
A bad catalytic converter can also cause your Kia / Hyundai not to accelerate. Typically you can get to speeds over 50mph when the catalytic converter is defective, but it may take a while for the car to get up to that speed. When the catalytic converter gets clogged it creates excessive backpressure, and thus the vehicle loses power. You can have a muffler shop perform a backpressure test on your vehicle.
This will confirm if the catalytic converter is defective or not. Replacing cat converters can be expensive. They can cost close to $1,000 if you want an OEM catalytic converter but aftermarket units cost only $200-$300 USD at a muffler shop.
If you are up to the challenge you can order a universal catalytic converter online for under $100 and replace it yourself.
Several fault codes may be present when the vehicle fails to accelerate. You can use OBD2 scanner reader to retrieve the codes from your car.
Here is the list of codes that were triggered by a defective TPS.