2004-2008 Chrysler Crossfire Check Coolant How to Add Antifrezee
HUB: Chrysler, Crossfire 2004-2007 Updated Wednesday Oct 18, 2017
Instructions on how to check coolant level on a Chrysler Crossfire. Applicable to model years 2004, 2005, 2006, 2007, 2008.
What you will need
Step 1 - Open Hood
Locate the hood release underneath the dashboard of your Chrysler Crossfire. Pull the lever until you hear the Chrysler hood pop open. Next, you need to release the hood safety latch at the front of your Crossfire.
Step 2 - Locate Coolant Reservoir
Next, locate the coolant reservoir (tank) on your Chrysler. Here you add engine coolant in a Chrysler Crossfire. On a Crossfire the coolant reserver is located on the passenger side.
Step 3 - Check Chrysler Crossfire Coolant Level
Look at the coolant reservoir tank and note the low and high level. If the level is below the minimum mark you will need to add coolant or your Crossfire may overheat.
Step 4 - Remove Cap
Remove coolant reservoir cap. Do this slowly as any residual pressure can cause the cap to blow off.
Step 5 - Add Coolant / Antifreeze
Add engine coolant/antifreeze. Only add coolant type recommended by Chrysler.