Learn how to check power steering fluid on your Chrysler Crossfire. This guide applies to Chrysler Crossfire produces during these years: 2004 2005 2006 2007 2008. If the power steering fluid is low, add the recommended fluid type ASAP. Otherwise, your Chrysler Crossfire may develop a loud whine when you turn the steering wheel. If you continue to drive your car with no power steering fluid in it, you can burn the power steering pump. Start your Chrysler and turn the steering wheel from lock to lock several times. Do this three or four times before you check the power steering fluid on your Chrysler.
Step 1: Open hood
Locate the hood release underneath the dash. Pull the lever until you hear the hood pop open. Next, you need to release the hood safety latch at the front of the hood.
Step 2: Locate power steering reservoir
Next, you need to locate the power steering pump on your Chrysler Crossfire, In this case, the power steering pump is located on the driver side of the engine bay.
Step 3: Remove power steering cap
Once you locate the power steering reservoir on your Chrysler Crossfire, remove the cap. Inspect current condition of the the power steering fluid.
Step 4: Determine Low and High marks
If you look carefully on the side of the power steering fluid or the cap dipstick you will notice a Low and Max level for the power steering fluid. Determine if the current power steering level is below the minimum level.
Step 5: Add power steering fluid
Adding power steering fluid on 2004-2008 Chrysler Crossfire is very easy. Here are some general instructions on how to add power steering fluid on a car. Instructions on how to add power steering fluid on a car.