2004-2008 Chrysler Crossfire Oil Change DIY Guide

2004-2008 Chrysler Crossfire Oil Change DIY Guide

Last Updated on Thursday Oct 19, 2017

In this guide you will learn how to change the oil filer on a Chrysler Crossfire.

What you will need


Step 1: Raise Vehicle

Drive the car over up on ramps. Place the car in park and set the barking brakes.

Step 2: Remove engine splash shield

Remvoe the plastic shield under the engine of your Crossfire.

Step 3: Locate oil drain plug on Crossfire

The oil drian plug on a Crossfire is a 13mm bolt.

Step 4: Drian Oil

Remove oil drain plug. Allow the old oil to drain. The oil may still be hot. Avoid touching it.

Step 5: Replace drain plug washer

Replace the drain plug washer if you have one. Reinstall the oil drain plug.

Step 6: Install drain plug

Reinstall the drain plug on your Crossfire.

Step 7: Locate engine oil filer Chrysler Crossfire

Locate the engine filer on your Chrysler Crossfire. Use a filter wrench to remove the oil filter.

location of engine oil filter on Crossfire 2004 2005 2006 2007 2008 diy oil change

Step 8: Replace the oil filter

Remove the old oil filter. Install the new filter on your Crossfire and tighten it by hand. Next, torque the filter to spec 25Nm.

Step 9: Locate oil filler cap

Locate the oil filler on top of your Crossfire's engine.

Step 10: Add engine oil

Add the recommended engine oil. Check the oil level after you add 8% of the capacity. Don't overfill engine with oil.