How to Add Antifreeze / Check Coolant Level on Chrysler Crossfire

Vehicle: chrysler   Crossfire
Difficulty: ⚫⚪⚪⚪⚪
DIY Cost: $10-$20
Est. Time: 5 min

In this guide, you will find instructions on how to check the coolant level on a Chrysler Crossfire.

Procedure

  1. Locate the hood release underneath the dashboard in your Chrysler Crossfire. Pull the lever until you hear the Chrysler hood pop open. Next, you need to release the hood safety latch at the front of the hood.

  2. Next, locate the coolant reservoir (tank) on your Chrysler. On a Crossfire, the coolant reservoir is located on the passenger side.How to check coolant or add 2004 2005 2006 2007 2008 Crossfire
  3. Look at the coolant reservoir tank and take note of the low and high level. If the level is below the minimum mark, you will need to add coolant or your Crossfire may overheat.
  4. Remove the coolant reservoir cap. Do this slowly as any residual pressure can cause the cap to blow off. Only remove the cap when the engine has cooled down.Add engine coolant antifreeze Chrysler Crossfire 2004 2005 2006 2007 2008
  5. Add engine coolant/antifreeze. Only add the coolant type recommended by Chrysler.

Applicable to model years 2004, 2005, 2006, 2007, and 2008.

By YOUCANIC Automotive Experts
Jul 2020