BMW Radio Removal and Replacement Instructions

BMW Radio Removal Replacement DIY

Last Updated on Wednesday Jun 06, 2018

In this guide, we will take a look at how to remove the radio from BMW vehicles. The radio on BMW vehicles has several functions including the Navigation GPS, Bluetooth module, CD drive and is the brains of the iDrive. If it fails your BMW iDrive will not work and may keep restarting. For more information on common BMW radio problems see this article.

Removing the radio from BMW vehicles may seem difficult due to the fact that the radio is not your typical double din head unit. In fact, removing and installing BMW radio is very simple and can be completed in less than 30 minutes. 

The pictures and video are from a BMW 5-Series. Owners of 1, 3, 5, 6, 7, 8, X3, X5 series will also find these instructions helpful. 

What you will need: 

Service (Optional)

BMW Radio Removal Instructions

  1. Disconnect the battery. On most BMWs including 3-series and 5-series models, the battery is in the trunk. Remove the dashboard center trim. Use the dashboard removal tool to pry out the trim. In this case, there are no bolts that need to be removed. bmw remove dashbaord trim to remove radio

     

  2. Unplug the wire from the back of the hazard light. BMW radio removal require the removal of climate control buttons knobs
  3. Remove two screws that hold climate control knob in place. Pull out the trim for the climate control. Be careful when pulling out the trim and don't bend it or it may crack. BMW radio trim removed

     

  4. Remove the four screws on the front of the radio. This is your CCC or CIC unit. BMW radio ccc cic removed 1 3 5 6 7 8 x1 x3 x5 series

     

  5. Slide out BMW radio to remove it. BMW radio navigation drive pulled out

     

  6. Unplug the antenna, optical cable and the rest of the wire harnesses from the back of the BMW radio.This is how you remove BMW radio double din from dashbaord idrive  
  7. Install in reverse order. 

Don't forget to disconnect the battery when replacing BMW radio. Otherwise, you will set fault codes on various modules if you turn on the ignition when the radio is removed. If you accidentally turn on the ignition and the battery is connected you will need to use a BMW specific scanner to read and clear any codes that may set. 

If you are replacing your BMW radio with a used BMW radio , it will require to be coded and to match the VIN in your car. While a used BMW radio from another vehicle will work, some of the functions may not work. For example, if your BMW has Bluetooth hands free calling installed but the car that the radio came from didn't have Bluetooth your Bluetooth will not work. Until the installed radio has been coded to match your BMW options. 

 

Related Videos