In this guide, you will find step-by-step instructions on how to check the Lexus engine oil level.

To check the engine oil level on a Lexus, the engine must be at operating temperature. Turning off the engine and wait at least five minutes for the oil to return into the oil pan. Check the oil level using the dipstick with a yellow handle. To get an accurate reading, make sure the vehicle is on a level ground.

For more help, follow the step by step instructions below. 

What you will need

  • A dry clean cloth
  • Synthetic Engine Oil
    • Recommended grade listed in the owner's manual or oil cap. 
    • Use 5W-30 is recommended oil is not available. 
    • Needed only if the oil level is low. 

Procedure

  1. Park your Lexus on level ground, set the parking brakes and turn off the engine. Parked lexus
  2. Wait at least 5 minutes to allow the engine to cool down and the oil to return to the oil pan. 
  3. Open the hood of your car by pulling the release lever located under the left side of the dashboard, driver’s side.Opening Hood

     

  4. Depress the safety lever under the hood to open the hood.Depress hood latch
  5. Locate the engine oil dipstick on the engine block. Oil dipstick typically has a yellow handle.2011-Lexus-LX570 (47) oil dipstick2007-Lexus-IS-250 (131) oil dipstick 2004-Lexus-ES-330 (96)_ oil dipstick location1991-Lexus-LS400 (52) oil dipstickLocating Dipstick

     

  6. Remove the dipstick and wipe it with a dry clean cloth. Remove Dipstick

     

  7. Note the MIN and MAX marks on the dipstick. Oil level max and min

    In this next picture, the MAX and MIN levels are marked by two dots. 

    Checking min max of the dipstick
  8. Fully reinsert the dipstick and remove it once again.
  9. Check the oil level on the dipstick.OIL LEVEL
    • If the level is between the MIN and MAX marks the level is correct.  
    • If the oil level is below the minimum mark, then your oil level is too low, and you need to add oil. Continue to the next step. 
  10. Remove the oil cap on top of the engine by turning it counter-clockwise. If the cap has not been removed in a long time it may be difficult to remove and may require force. Oil Cap Removal

     

  11. Add one quart of recommended engine oil that meets the requirements listed in your owner’s manual.  
  12. Wait 5 minutes and recheck the engine oil level again using the dipstick. 
  13. Continue your journey only if the oil level is between the MIN and MAX marks. Do not continue to drive if the oil level is low or the oil light on the dashboard stays on. 

Do not overfill the engine with oil. The oil level should not be over the MAX mark.  If the oil level is above the maximum mark, then you need to remove oil to bring the level between the MIN and MAX marks.

Ideally, the oil level should fall within the minimum and maximum markings of your dipstick, but closer to the maximum marking.

We hope you found this guide helpful. Please consider showing your support for YOUCANIC by subscribing to our YouTube channel.

Thank you!