How to change Nissan Turn Signal Headlight Wiper Switch Replacement combination switch

Nissan Turn Signal Headlight Wiper Switch Replacement

Updated Wednesday Dec 06, 2017

In this guide, you will learn how to replace the combination switch on Nissan vehicles. Nissan combination switch has multiple parts including the turn signal switch, headlight switch, low/high beam stalk, and wiper switch. The video clips on this tutorial were recorded on a 2017 Nissan Quest but these instructions should help owners of Nissan Versa Altima Maxima Rouge Murano Titan as well. This guide generally applies to Nissan years: 2011 2012 2013 2014 2015 2016 2017. 

The cost to replace Nissan combination switch yourself ranges in the $75-$250, see link under parts needed. The cost to replace Nissan combination switch at the dealer or auto repair shops ranges in between $700-$1200.

Back to top

1. Symptoms

If the combination switch fails on your Nissan you will notice one or more of the following problems. 

  • Nissan Turn Signals don’t work,
  • Wiper does not work,
  • Turn signal does not cancel,
  • Low or High stalk does not work
Back to top

2. What you will need

Parts Required:

Tools Needed:

Back to top

3. Instructions

Step 1

Park your Nissan and set the parking brake. Remove the key from the ignition of your Nissan.

How to change turn signal switch on Nissan 2011 2012 2013 2014 2015 2016 2017

Step 2

Disconnect the negative battery cable from the battery terminal.

Step 3

Remove Torx bolts on the side of the steering wheel.  You will need to use secure Torx bit with a hole in the center.

Unplug the wires from the back of the driver's airbag.

Watch video on how to remove Nissan airbag.

Step 4

Remove center bolt that secures Nissan steering wheel to the steering column. Mark the steering wheel and column before you remove the steering wheel.

Remove steering wheel and spiral calbe on Nissan Quest Altima Maxima Rouge Murano Titan

Unplug steering wheel button wire harness.

Watch video on how to remove Nissan steering wheel.

Step 5

Remove the plastic trim.

Clock spring problem causing Nissan airbag light light to come on

Watch video on how to perform this step.

Step 6

Next, you need to remove the clock spring which is held in place with several screws.

Replace the clock spring if your Nissan horn does not work

Unplug the wires from the clock spring.

In this case, the clock spring and Nissan steering angle sensor are integrated together.

Remove Nissan Quest Altima Maxima Rouge Murano Titan combination switch which has the turn signal and wiper stack in it.

Step 7

Install new Nissan spiral cable/clock spring. The clock spring needs to be installed in neutral position. Don't wind it up to the left or right. Clock spring has a limited number of turns. If you turn it all the way to one side, the ribbon can't take more steering wheel turns or it may get damaged shortly after installation.

Step 8

Watch video on how to install Nissan clock spring/spiral cable/steering angle sensor.

Nissan combination switch turn signal wiper

Install Nissan steering column cover.

Step 9

Install the plastic cover before you install the steering wheel.

Step 10

Install the steering wheel and torque the center bolt to 30-35Nm.

Step 11

Install the airbag. Connect the steering wheel and airbag wires. Torque the bolts that secure the airbag to approximately 8-10Nm.

 

Back to top