In this guide, you will find step-by-step instructions on how to remove and replace the airbag on a Volkswagen. While the pictures are from 2016 VW Jetta, the procedure is almost identical for all Volkswagens, including Golf, EOS, Passat, Golf, etc. 

Before you start

  • Disconnect the battery negative terminal 15 minutes before you start work. 
  • Make sure the steering wheel remains unlocked when you disconnect the battery. You will need to turn the steering wheel.
  • Handle the airbag with care. 
  • Keep at least one to two distance from the airbag at all times. 
  • Don't test airbags with a multimeter. 

What you will need

You only need basic tools to remove a VW driver's airbag. 

  • Flathead screwdriver
  • Gloves

Instructions

Here is how you can remove and replace a VW airbag from the steering wheel. 

  1. Turn on the ignition and make sure the wheels are pointing straight forward.getting ready to remove change Volkswagen VW driver airbag Jetta
  2. While the ignition is on disconnect the battery this ensures the airbag won't deploy and the steering wheel remains unlocked so that you can still turn it.Disconnect vw battery before you change remove airbag

     

  3. Press the brake pedal a couple of times then wait at least 15 minutes before you continue to the next step. By pressing the brake pedal we are making sure any electrical charge in the ECU is completely discharged. 
  4. Lift up the upper steering column trim. Use a dashboard removal try to pry the top trim. Usually, there are no screws, just clips. VW steering column trim
  5. Turn the steering wheel 90 degrees so that the hole that is on the side of the steering wheel is at the top.VW driver airbag release The hole is accessed from the back.  Look for a whole at the back of the steering wheel. The 2015 and older VW vehicles, had an easy to access hole on the back of the steering wheel. 2016 will not have a visible hole, but you should see a small indent. If the airbag has never been removed, the hole will be closed. Use a screwdriver to puncture this hole. 
  6. Press the screwdriver towards the center of the steering column. This will release the airbag on one side. how to release vw airbag
  7. Turn the steering wheel 180 degrees to access the second hole on the other side of the steering wheel.  
  8. Puncture a hole on the other side where the small indent is present. 
  9. Release the airbag on the other side will allow you to remove the airbag. Have a helper hold the airbag as you release the second spring so that the airbag does not fall. vw airbag removed
  10. Next, you need to disconnect the airbag. You can disconnect the wires from the airbag.vw airbag connectorThe other option is to disconnect the one connector to the steering column. disconnect vw airbagIn either case, you need to release the locking tab first then disconnect the electrical connectors. 

Releasing the airbag on a Volkswagen can be tricky and requires patience. Especially if you are removing a VW airbag for the first time, make sure to watch our video on VW airbag removal and check out all the pictures. You will have a better understand and what needs to be done. 

Can I install a used VW airbag? 

Yes, in theory. You can install a used airbag, but it is not recommended. A used airbag many not function or ignite appropriately in case of an accident. 

Also, check your local laws.

Does a VW airbag need to be programmed? 

No, when you install a used or new VW airbag, no programing for the airbag is required. The airbag light can be cleared with a VW scanner. Check out our guide on VW airbag light stays on.

We hope you found this guide helpful. Please consider showing your support for YOUCANIC by subscribing to our YouTube channel.

Thank you!