Eventually, keyless remote batteries die just like any battery. You may be stranded in such an event. But, did you know that there is a manual entry into modern vehicles, and they can also still be started even with a dead key fob?
Keep on reading to find out how to use your dead key fob to open your vehicle even in case of an emergency.
Common causes of a bad key fob/keyless entry remote:
- The battery in the remote has died
- The remote has failed, oftentimes due to wear or moisture
- The fuse in the vehicle for the remote system has blown
- The keyless entry system module or wiring has failed or malfunctioned
- On the back of the key fob, there is a tab that can be pushed to release the metal key from it. Push this tab down and pull the metal key out of the plastic casing.
- Use the metal key to unlock the driver's side door on the vehicle.
- Insert the metal key back into the fob.
- Locate the hole for inserting the fob on the lower part of the center of the dash. Insert the key fob into this hole and the vehicle can be started even with a dead battery in the key fob.
- Use the push to start as you normally would while keeping the key fob in the socket.
- If the vehicle battery is dead, use a jump starter to start the vehicle, refer to this guide.
- Replace the malfunctioning key fob or key fob battery. You are all done!
All Mitsubishi models including Galant, Lancer Evo, Outlander, Eclipse, Mirage, and more. All year models including current-gen: 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, and 2021.
I replaced my key fob, do I need to have it programmed at the dealer?
The short answer is yes, a new remote will need to be reprogrammed. Usually, due to restrictions on the software used for reprogramming these vehicle's computers, the car will also have to be taken to a dealer. However, aftermarket software and professional tools do exist that may be able to perform these functions.