E1962 Plausibility error between the selector lever position of component A80 (Inteligent servomodule for DIRECT SELECT) and of control unit Y3/8n4 (Fullyintegrated transmission control(VGS)control unit)

This fault know repair conductor plate ? or need new buy?

Comments

First I would check the 13 pin connector for oil. If that has no oil then my guess is that it is a bad conductor plate. You can clean it but there is no guarantee that it will work. If it was me I would get a new one. They are cheap enough nowadays.

I checked the connector, cleaned the valve body I put new oil. But nothing the same problem. Diagnostics shows turbine sensor data that can be measured by a sensor at a level.is it possible to fix conductor plate? where can I buy a new Conductor plate?

There are repair shops that can fix them. Considering that a new conductor plate runs around $100 it makes sense to just install a new one. Check eBay and Amazon.

Plain text

  • Allowed HTML tags: <a href hreflang> <em> <strong> <cite> <blockquote cite> <code> <ul type> <ol start type='1 A I'> <li> <dl> <dt> <dd> <h2 id='jump-*'> <h3 id> <h4 id> <h5 id> <h6 id>
  • No HTML tags allowed.
  • Lines and paragraphs break automatically.
  • Only images hosted on this site may be used in <img> tags.
The content of this field is kept private and will not be shown publicly.

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.