Hi, my drivers side indicator in the mirror has stopped working, fitted a new one as old one had water in it. The plug was slightly corroded I cleaned it and put some wd40 in but nothing any help would be appropriated, thanks Andy 

Comments

When car is scanned with VCDS, there may be a fault code. A normal scanner sometimes only read powertrain codes but do not read anything else. Mirrors and Windows are controlled by the computer module residing beside the door. So it is most likely a broken wire in it. you should check with a VCDS for faults, It might tell you something like wiring or communication fault. Further troubleshooting can begin after that  

Try to clean the corroded plug using electrical contact cleaner if nothing happen proceed to scan your vehicle to determine the possible causes.

Plain text

  • Allowed HTML tags: <a href hreflang> <em> <strong> <cite> <blockquote cite> <code> <ul type> <ol start type='1 A I'> <li> <dl> <dt> <dd> <h2 id='jump-*'> <h3 id> <h4 id> <h5 id> <h6 id>
  • No HTML tags allowed.
  • Lines and paragraphs break automatically.
  • Only images hosted on this site may be used in <img> tags.
The content of this field is kept private and will not be shown publicly.

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.