Hi, I have an e280 w210 2000 tiptronic. I spilt drink down the selector and have fitted another used one but fault is still there. The supplier told me the system nearly always needs to be reset. Can this be done with carsoft or equivalent?
Thanks

Comments

The reason why it is still is in limp mode is because a hard code has been set. iCarsoft MB II can not clear the codes on W210 because it doesn't have a 38 pin connector required for the W210. A couple of scanners that would work are Carsoft 7.4 Multiplexer or Autel DS708. It may be worth to visit a shop that has a good scanner and pay them .5 hr labour to reset the codes. Good luck.

Plain text

  • Allowed HTML tags: <a href hreflang> <em> <strong> <cite> <blockquote cite> <code> <ul type> <ol start type='1 A I'> <li> <dl> <dt> <dd> <h2 id='jump-*'> <h3 id> <h4 id> <h5 id> <h6 id>
  • No HTML tags allowed.
  • Lines and paragraphs break automatically.
  • Only images hosted on this site may be used in <img> tags.
The content of this field is kept private and will not be shown publicly.

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.