How to Remove and Replace Air Filter on a Mitsubishi Outlander

DIY Cost: $20-$35
Est. Time: 20 min
Difficulty: Very Easy

This guide provides instructions on how to remove the airbox and replace the air filter on a 2019 Mitsubishi Outlander. This repair is simple and straightforward. 

Follow along with our step-by-step instructions and you can save time and money by doing it yourself. You can also watch the video for a visual in-depth tutorial that shows you everything you need to know.

What you will need

Tools

Parts

Procedure

Follow these steps to change the engine air filter on the Mitsubishi outlander: 

  1. Start by opening the hood. Look for the airbox on the driver's side of the vehicle.
  2. Remove the two plastic retainers holding down the air inlet to the radiator support. Pry them up with a flathead screwdriver or trim tool and pull them out.
  3. Push the air inlet up until it pops off the airbox.
  4. Loosen and remove the 10mm bolt on the right side that is holding the bottom of the airbox down. 
  5. Loosen the hose clamp around the air filter box neck near the mass airflow sensor. Use a 10mm socket and ratchet or a flathead screwdriver.
  6. Remove the plastic fastener from the side of the airbox that is holding the mass airflow wiring. Simply squeeze the part that is pushed through the airbox hole and push it back out of the hole it is in.
  7. Remove the mass airflow sensor by pushing down on the plastic tab on the back of it and pulling it off the sensor. If needed, use a small flathead screwdriver to carefully pry the connector off by lifting the front of the plastic tab over the part of the protruding part of the sensor that keeps the tab locked in place. Move the wiring and connector out of the way.
  8. Pull the vacuum hose off on the left rear of the airbox by hand.
  9. Pull the airbox straight up. It has a plastic peg on the right rear that pops into a rubber grommet on the body of the vehicle that it will pop out of. Pull the airbox out of the hose that is connected to the elbow with the mass airflow sensor in it.
  10. Here you can remove the air filter from the box by unlocking the metal tabs and pulling the side with the mass airflow sensor up and out. The two pieces will separate, be sure to align the two tabs on the bottom into their holes when putting it back together.
  11. Reverse the procedure to reinstall the airbox, you are all done!

How often should I change the engine air filter on a Mitsubishi Outlander? 

It is recommended to change the engine air filter every 20,000 miles or every other tire rotation. If you don't know when it was last changed, it might be a good idea to do it yourself. If it has been a while, you can visually check the filter. Over time, dirt and debris build up on the filter. You should write down your maintenance somewhere you can keep track of it, such as in your owner's manual.  

Do I need to take the airbox off to change the filter? 

This specific model is quite difficult to open the airbox on so that the filter can be changed. It is best just to take the time to take the airbox out. Also, the air filter will sit in a good position and the airbox will be sealed properly when the engine is put back together. However, some of Mitsubishi's different models have been made so that the filter can be changed more easily.  

Vehicle Applications

Mitsubishi Outlander

2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, and 2021


Was this helpful?
We would love to hear from you. Send us tips on how to improve this article.
Send us message if you have any car questions.

Tip!
Check out more guides for the following vehicle.
How to Remove and Replace Air Filter on a Mitsubishi Outlander Follow along with our step-by-step instructions and you can save time and money by doing it yourself. You can also watch the video for a visual in-depth tutorial that shows you everything you need to know.