Skip to main content
Guide on how to replace the high beam light of the Nissan Rogue Sport 2017+.

Table of Contents

Watch Video

What you will need

Procedure

  1. Open the hood. Pull the hood release under the dashboard and unlock the hood latch on the vehicle's front.The hood release of the Nissan Sport Rogue.Then pull the hood up and set the hood strut to secure the hood open.Opening the hood of the Nissan Rogue Sport.
  2. Remove the push clip attached to the air filter housing and back air intake housing by pulling it out using a fastener remover tool or a pick tool.Removing the push clip attached to the air filter housing and back air intake housing..jpg
  3. Remove the back air intake housing by pulling it out of the vehicle.Removing the air intake housing above the vehicle's battery.

     

  4. Remove the two push clips on the front intake housing and one 10mm bolt on the backside of the front intake housing. Turn the bolt counter-clockwise using a 10mm nut driver to remove it.Removing the bolt holding the front air intake housing.

     

    Removing the push clips on the front air intake housing.
  5. Remove the front air intake housing by pulling it out of the vehicle. This procedure helps to have wider accessibility on the light bulbs behind the driver's side headlight assembly.Removing the front air intake housing of the Nissan Rogue Sport.

     

  6. Locate the high beam light bulb behind the headlight assembly.The location of the high beam light on the driver's side.

     

  7. Disconnect the electrical connector of the light bulb by pressing its clip and pulling the connector out.
  8. Twist the light bulb 90° counter-clockwise and pull it out to remove it from the headlight assembly.The high beam light bulb of the Nissan Rogue Sport.

     

  9. Insert the new light bulb into the headlight assembly and twist it 90° clockwise to lock it in position.
  10. Connect the high beam electrical connector to the new light bulb by pushing it towards its connection port on the light bulb.
  11. Check the new light bulb before reinstalling the front and back air intake housing.