Ford Fusion Window Regulator Replacement Guide

What you will need

• Ford Fusion Window Regulator Motor
• Ford Fusion Window Regulator
• Prying tool
• Pick tool
• Mechanic Toolset
  • 10mm socket
  • T30 Torx bit socket

Procedure

1. Remove the door panel. If you need help with this step, follow these procedures for the removal of the door panel.

    

2. Remove the window. If you need help with this step, follow these procedures for the window removal process.

    

3. Remove the cover of the window regulator motor by pulling it out using a prying tool or pick tool.

    

4. Disconnect the electrical connector of the motor by pressing the clip and pulling the connector out.

    

5. Remove the five 10mm bolts holding the door panel by using a 10mm nut driver or a 10mm socket and twisting it counterclockwise to loosen.

    

6. Reach inside the door and carry the window regulator and the motor out of the vehicle.

    

    

   

    

   
7. To replace the motor, remove the three T30 bolts and pull the motor out of the window regulator. Use a T30 Torx bit socket to remove the bolts.

    

8. Line up the new motor to the window regulator and reinstall the three T30 bolts.
   

    

9. Install the window regulator and motor to the door. Place the piece inside the door and line it up to its proper position.

    

   
10. Reinstall the five 10mm bolts holding the whole window regulator piece. Twist the bolts clockwise to tighten.
    

     

11. Reconnect the electrical connector of the motor by pushing the connector into the motor.

     

12. Line up the cover of the window regulator motor and press it in until it snaps into place.

     

13. Reinstall the window. If you need help with this step, follow these procedures for the window installation process.

     

14. Reinstall the door panel. If you need help with this step, follow these procedures for the installation of the door panel.