Skip to main content
This article provides step-by-step instructions and video clips on how to replace the clock spring on a Honda Civic.

Table of Contents



These are some of the most common symptoms of a bad clock spring on a Honda vehicle.

  • Airbag / SRS Light on
  • Horn doesn't work
  • Traction Control / Stability Light On
  • Cruise Control doesn't work.

Share your symptoms in the comment section below.



  1. Pull the hood release under the dashboard. Open the hood and disconnect the negative battery terminal. disconnect battery to replace honda clock spring
  2. Wait fifteen minutes before starting to work on the airbag system. 
  3. Remove two Torx screws on the side of the steering wheel. A panel on the bottom of the steering wheel will allow you to disconnect the airbag wires. Remove the airbag.clock spring replacement honda civic 9th generation
  4. Remove the 14mm bolt that secures the steering wheel in the steering column. remove bolt to remove replace clock spring Honda vehicles accord civic odysseyNext, remove the steering wheel.
  5. Remove the plastic trim from the steering column. Note that one screw is at the bottom of the plastic civic accord clock spring replacement

    Watch the video on how to perform this step.

  6. Unclip the clock spring and disconnect the wires. Remove the clock spring.remove honda clock spring
  7. Install a new Honda clock spring in reverse order.
  8. Reconnect the battery. honda battery connect after changing clock spring

When installing a new clock spring, make sure that it is in the center. You can verify this before installation.

Turn the clock spring all the way to the right until you feel resistance. Now count how many turns it takes to rotate the clock spring all the way to the left. If it took 6 full turns, divide by 2.

From a full turn, the position comes back 3 full revolutions. This will be the center. The clock spring needs to have 3 full left or right turns available. Otherwise, the clock spring will get damaged shortly after it is installed.

SRS Light and Steering Angle Sensor Calibration

After you replace the clock spring, you may need to use an OBD-II scanner to clear the airbag codes or carry out the steering angle sensor (SAS) calibration. A generic OBD2 scanner will not be much help, but you can use scanners such as Launch Creader or Foxwell Full System Scanner to carry out these procedures.

Owners of Honda Accord, Pilot, Civic, Fit, CR-V, Odyssey, Jazz, City, Prelude, Amaze will also find this guide helpful. 

Frequently Asked Questions

Can I drive with a broken clock spring?

While you can drive a Honda with a broken clock spring, you are putting yourself at risk because the driver airbag may not deploy in case of an accident. Some functions such as stability control and ABS may be disabled as well.

Can I fix my broken Honda clock spring?

Repairing broken clock springs is extremely difficult. New and used clock springs are very cheap.

Are a clock spring and spiral cable the same?

A spiral cable is inside a clock spring and often breaks.

Honda clock spring prices?

A new Honda clock spring can cost anywhere from $60 to $200. Double that if you buy it from the dealer.