This guide provides step-by-step instructions on how to replace the brake light bulb on a Mitsubishi Mirage G4 sedan.
Table of Contents
What you will need
Procedure
- Open the trunk of your car by pulling the trunk release under the driver's seat.
- Remove the tail light. Remove the two screws holding the tail light and use a prying tool to pop out the tail light.
Then pull out the tail light once the clips have been unlocked. Use a screwdriver and turn it counterclockwise to remove the screw.
- Remove the brake light connector. Twist the connector counterclockwise to unlock it, then pull it out to remove the connector from the tail light.
The arrow indicates where the brake light can be found.
-
Remove and replace the brake light bulb. Once the brake light connector is out, remove the old light bulb by pushing it in and twisting it counterclockwise. Then replace it with a new one, to put the new one push the brake light bulb in then twist in clockwise. Make sure that the light bulb is in its proper position because the prongs of the bulb are not the same.
- Reinstall the brake light connector by pushing and twisting in its place. Twist the connector clockwise to lock the connector in.
- Reinstall the tail light on the vehicle. Align the tail light onto the clips and push it in to lock the clips of the tail light. Then screw back the two screws you removed from the tail light.
Tightening the screw of the tail light by turning it clockwise.
-
Close your trunk and test the new brake light by pressing on to the brake pedal.