
ESTIMATED TIME 10 - 15 mins
DIY COST $ 7 - 15
DIFFICULTY Very Easy
What you will need
Procedure
- Open the hood. Pull the hood release under the dashboard. Go to the front, unlock the hood latch and pull the hood up until the hood struts keep the hood open.
- Locate the light bulb connector behind the headlight assembly.
- Reach in, grab the electrical connector of the turn light bulb, twist it counterclockwise, and pull it out from the headlight assembly.
- Remove the light bulb by pulling it out.
Light bulb removed.
-
Install the light bulb to the connector by pushing it in.
- Line up the electrical connector back to the headlight assembly and twist it clockwise to lock it in place.
- Check the light bulb by switching on the turn signal light.
Notes
- Do not touch light bulbs with bare hands as that can shorten the life of the light bulb.
- Installing LED bulbs:
- If you are upgrading to LED light bulbs, and the bulb doesn't turn on when you install it simply remove the LED bulb and rotate it 180 degrees and reinstall it.
- Certain vehicles may trigger a fault message stating faulty or burned light bulb when the original bulb has been upgraded to LED. If that is the case, use halogen bulb or get an Error Free LED bulb.
Comments
Add new comment