2017+ Nissan Rogue Sport Front Bumper Replacement

What you will need

• Nissan Rogue Sport Front Bumper
• Floor Jack
• Jack Stands
• Fastener Remover Tool
• Philips Screwdriver
• Mechanic Metric Toolset
  • 10mm 3/8" Socket
  • 3/8" Ratchet Wrench

Removal

1. Park the vehicle on ground level.

    

2. Jack up the vehicle's front and support it with jack stands.
3. Remove the engine splash shield by pulling out all the push clips holding the engine splash shield. Use a fastener remover tool to remove the push clips.

    

4. Remove the two screws holding plastic trim on the front fender. Use a Philips screwdriver and turn it counterclockwise to remove the screws.

    

5. Once the screws are removed, pull the plastic trim out from the vehicle's fender.

    

6. Remove the 10mm bolt inside the edge of the front bumper by turning it counterclockwise using a 10mm socket.

    

7. Pull the edge of the front bumper out from the fender and headlight assembly.

    

8. Repeat procedures 4-7 on the other side of the vehicle.

    

9. Remove the bumper support bracket by removing the push clips and screws holding to it. Use a Philips screwdriver and fastener remover tool to remove the screws and push clips. 

    

10. Remove the two push clips behind the front bumper grille. Use a fastener remover tool to remove the push clips.

     

11. Lift up and remove the front bumper from the vehicle.

     

    

Installation

1. Line up the new/replacement front bumper to the vehicle and press it in to set the tabs holding to the front bumper.

    

   
2. Reinstall the two push clips behind the bumper grille by pressing the push clips into their installation ports.

    

3. Line up the edges of the front bumper to the channels on the headlight assembly and fender. Then press the front bumper in until it snaps into place.

    

   
4. Reinstall the 10mm bolt inside the edges of the front bumper by turning it clockwise using a 10mm socket.
5. Place the plastic trim back to the vehicle's fender and reinstall the two screws holding it.

   Repeat the procedure on the other side of the vehicle.

6. Place the bumper support bracket back on the vehicle. Then reinstall the screws and push clips to set the bumper support bracket into place.

    

7. Line up the engine splash shield back under the vehicle and reinstall its push clips to secure it in place.