Acura Ignition Coil Replacement Guide

Changing the ignition coil on Acura vehicles is not as difficult as you may think. The four-cylinder Acura engine is very easy to work on and you can change the ignition coils yourself in less than one hour.

The 3.5L V6 Acura engine requires slightly more time. To change all Acura coils at the local Acura dealer or auto repair shop it costs anywhere from $400-$600. Doing this job yourself typically costs about $100-$150, in some cases even less. 


The most common symptom that you have a bad ignition coil is Acura check engine light coming on and engine misfire. While you can change ONLY the defective coil, it is recommended to change all coils at one. If you are in tight budget replace only the bad coil but keep in mind that another coil may fail a few months down the road. 

What you will need

Acura ignition coils can be purchased online, at your local Acura dealer or local auto parts store. Below we have provided a link where you can check the price and buy Acura ignition coil.


Changing Acura ignition coils is a very simple job that you can perform yourself. 

Park Vehicle

Park you ACURA on a level ground. To avoid getting burned, allow the engine to cool down before you start replacing Acura ignition coils.


Open Hood

Pull the hood release located under the dashboard (driver's side) of your Acura. 


Disconnect Negative

To avoid electrical problems we need to disconnect the negative battery terminal on your Acura. The cable you need to disconnect is the black cable. The battery post that will be disconnected will either have the minus (-) symbol or the words NEG, NEGATIVE printed. The positive (RED) cable can remain connected. 



Remove Engine Cover

Remove the engine cover. In most ACURA the engine cover can be removed simply by pulling it up. Remove any 10mm bolts that you see on top of the engine cover.

remove acura engine cover to change ignition coil


Disconnect Ignition Coil

remove acura ignition coil

Unplug the electrical connector from the ignition coil. Press the small tab then pull. Repeat this step for all coils.

acura tl ignition coil diy

Ignition coil on Acura TL.

acura tlx igntion coil diy

Ignition coil on Acura TLX.

Remove Bolt

ACURA ignition coil replacement diy

Remove the 10mm bolts that secure the ignition coil in place.

Remove Ignition Coil

Remove ignition coil from the engine block. It may be difficult to pull out the coil. If that is the case try twisting the coil as you pull it out. 

Install new ignition coil

Install new ignition coils on your ACURA engine. It is recommended to apply dielectric grease to the boot whenever possible. 

Reinstall Engine Cover

Reinstall engine cover. Connect the negative terminal and start the car.

igntion coil diy ACURA model 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019


This guide includes instruction on how to change Acura ignition coils on models such as MDX, NSX, RDX, RL RLX, RSX, SLX, TL TLX, ZDX, CDX, CL, VSX, EL, ILX, Integra, Legend .

  • It is recommended to disconnect the negative battery when replacing the ignition coils. 
  • If the old ignition coils don't come out, try twisting the coil as you pull it out. 
  • Take pictures before you remove the coils. You can move coils around but the electrical connectors cannot be moved from one cylinder to another. 


💡 Help us improve this article by providing feedback. No registration is required. 

Need Help?

💭 Ask car questions in our Car Forum.

Add new comment