How to Add Antifreeze / Check Coolant Level on Chrysler Crossfire

Instructions on how to check coolant level on a Chrysler Crossfire. Applicable to model years 2004, 2005, 2006, 2007, 2008.

What you will need

Tools

Instructions

Open Hood

Locate the hood release underneath the dashboard of your Chrysler Crossfire. Pull the lever until you hear the Chrysler hood pop open. Next, you need to release the hood safety latch at the front of the hood.

Locate Coolant Reservoir

Next, locate the coolant reservoir (tank) on your Chrysler. On a Crossfire the coolant reservoir is located on the passenger side.

How to check coolant or add 2004 2005 2006 2007 2008 Crossfire

Check Coolant Level

Look at the coolant reservoir tank and note the low and high level. If the level is below the minimum mark you will need to add coolant or your Crossfire may overheat.

Allow engine to cool down then remove Cap

Remove coolant reservoir cap. Do this slowly as any residual pressure can cause the cap to blow off. Only remove the cap when the engine is cooled down.

Add engine coolant antifreeze Chrysler Crossfire 2004 2005 2006 2007 2008

Add Coolant / Antifreeze

Add engine coolant/antifreeze. Only add coolant type recommended by Chrysler.

By YOUCANIC on Jan 9, 2019

Vehicle

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.