Remove rear tail light assembly
Open the rear service cover. You will notice three 10 mm bolts. Remove all the bolts. Disconnect the electrical wire connector. Pull out the tail light assembly.
Change side marker light bulb
Twist the side marker socket counterclockwise to remove it from the headlight assembly. Pull out the light bulb. Install the new light bulb. Reinstall the socket into the brake light assembly. Line up the three tabs with the slots found on the tail light assembly. Insert the side marker socket and twist it.
Reinstall the tail light assembly.
Tighten the three 10 mm bolts. Close the service cover. Make sure to reconnect the electrical wire before you close the service cover.
Help us improve this article by submitting a comment. All feedback, suggestions, comments, and corrections are welcomed.
💡 Need Help?
Join our community to get help with your car questions, show off your ride, connect with car enthusiasts, mechanics and more. It's easy, fast and free. 👉 Continue
Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.