How to check engine oil level Chrysler Crossfire

This guide shows you how to check Chrylser Crossfire engine oil level via the instrument cluster. For instructions on how to check oil level using the dipstick see this guide.

Checking Engine Oil Level
  1. Make sure the car has been shut off and on a level surface for at least 5 minutes.
  2. Turn key to ON/ RUN position.
  3. Wait about 10 seconds
  4. You will now see an oil icon along with a clock icon
  5. Press and hold the knob / button 2x and it will now display the oil level properties
  6. It will display the following : OK, -1.0Q, -1.5Q, -2.0Q, H
  7. OK = Oil level is ok

(-1.0 | -1.5 | -2.0) = Oil level is low, add the suggested amount of oil, run the car, shut it off, and check again when time allows.

H = Oil level is too high. Have some oil drained out of pan until it reaches the proper oil level limit. If you have just done an oil change, it is best to run the car for several minutes before checking electronically or manually. The oil filter will absorb some of the oil which could effect the readings.

If a clock is only displayed, it means you haven't let the car sit in the off position long enough. Wait a few minutes and try again.

You can also check the oil level from the dipstick located in the engine bay.

By YOUCANIC on Jan 11, 2019

Vehicle

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.