Chevrolet Sway Bar End Link Replacement

In this guide, you will find instructions on how to change sway bar links (also called stabilizer or end links) on Chevrolet vehicles.

Changing the sway bar end links is an easy job that can be completed in less than one hour.

To change Chevrolet sway bar links you will need a few basic tools. 

You do not need to carry wheel alignment when you replace the sway bar link. 

Symptoms 

  • Clunking noise,
  • Rattling from the front end,
  • Loose suspension,
  • Poor handling

What you will need

Instructions

Step 1

tie rod replacement guide

Jack up your Chevrolet and make sure to set the parking brake.

Step 2

Remove the front wheel. Place a jack stand under the vehicle to support it.

Step 3

Locate the sway bar link that you need to replace.

chevrolet sweay bar link

 

Step 4

Remove the nut that secures the sway bar link to the front strut.

Chevrolet  Spark, Sonic, Bolt, Volt, Cruze, Malibu, Impala, Camaro, Corvette, City Express, Trax, Equinox, Traverse, Tahoe, Suburban, Colorado, Silverado, Sonic, Blazer, Astro, HHR, Uplander, Avalanche etc. Sway Bar Link Location

 

Step 5

Remove the lower nut that secures the sway bar link to the sway bar.

 

Step 6

Install the new sway bar and torque the nuts according to the manufacturer specification.

By YOUCANIC on Jun 24, 2019

Vehicle

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.