When your Chevrolet check engine light stays on, it means that the On-Board Diagnostic (OBD) system has detected a problem with the engine, emission system, or transmission. A fault code is stored in the Engine Control Unit (ECU).
Chevy check engine light should only be on for a few seconds when you turn on the ignition and should turn off once the engine fully starts. If your Chevy check engine light stays on or is flashing, get the vehicle diagnosed as possible.
Chevrolet check engine lights may also be referred to as Malfunction Indicator Lamps.
Common symptoms include:
Chevy check engine lights may stay on but with no performance symptoms. Even if there are no symptoms, it is important to read the fault codes to determine why there is a CEL.
Common problems that cause Chevy check engine light to come on
Common problems that can trigger Chevy check engine lights to stay on include:
First, check the gas cap and make sure it is on tight. If the light doesn't reset within the next two to three days, read the fault codes.
Follow the instructions below to learn how to read and reset the Chevrolet service engine light codes. For this procedure, you will need an OBD-II scanner. You should only reset the check engine light and codes after all necessary repairs are completed.
- Locate the diagnostic port under the dashboard of your Chevrolet on the driver's side. This is a 16-pin port on all 1996, and newer Chevrolet vehicles have this port. Plug in your OBD2 scanner or Bluetooth adapter into the port.
- Turn the ignition ON, key in position II. All Chevrolet dashboard lights will turn on but do not start the engine. If your Chevrolet has Start/Stop button, you will need to press the START button without pressing the brakes.
- Allow your OBD2 scanner to turn on and connect to your Chevrolet Engine Control Unit (ECU). This step can take up to one minute.
- Read Chevrolet check engine light codes from the Engine Control Unit (ECU) using an OBD-II scanner.
- Once you have retrieved the codes, write them down. Research the codes and fix the underlying problem; you can come back and click Erase Codes to reset the Chevrolet check engine light.
The fault codes are just the starting point. Research every present code and common problem. Don't replace parts based on the fault code only. Get the opinion of a professional mechanic before replacing any parts.
The YOUCANIC UCAN-I scanner can read and clear codes on any 1996 and newer Chevrolet vehicle.