Chrysler Crossfire Oil Change Instructions

In this guide you will learn how to change the oil filer on a Chrysler Crossfire.

What you will need

Instructions

Raise Vehicle

Drive the car over up on ramps. Place the car in park and set the barking brakes.

 Remove engine splash shield

 Remove plastic shield under the engine of your Crossfire.

Locate oil drain plug on Crossfire

The oil drian plug on a Crossfire is a 13mm bolt.

Drian Oil

Remove oil drain plug. Allow the old oil to drain. The oil may still be hot. Avoid touching it.

Replace drain plug washer

Replace the drain plug washer if you have one. Reinstall the oil drain plug.

Install drain plug

Reinstall the drain plug on your Crossfire.

Locate engine oil filer Chrysler Crossfire

Locate the engine filer on your Chrysler Crossfire. Use a filter wrench to remove the oil filter.

location of engine oil filter on Crossfire 2004 2005 2006 2007 2008 diy oil change

Replace the oil filter

Remove the old oil filter. Install the new filter on your Crossfire and tighten it by hand. Next, torque the filter to spec 25Nm.

Locate oil filler cap

Locate the oil filler on top of your Crossfire's engine.

Add engine oil

Add the recommended engine oil. Check the oil level after you add 8% of the capacity. Don't overfill engine with oil.

By YOUCANIC on May 12, 2019

Vehicle

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.