Skip to main content

Fender Turn Signal Light Bulb Replacement Mitsubishi Mirage

This guide provides instructions on how to change the fender turn signal light bulb of the Mitsubishi Mirage.

 Fender Turn Signal Light Bulb Replacement Mitsubishi Mirage
ESTIMATED TIME 10 mins
DIY COST $ 10 - 25
DIFFICULTY Very Easy

What you will need

Procedure

  1. Locate the fender turn signal light bulb on the fender of the vehicle.Fender turn signal light bulb of the Mitsubishi Mirage.
  2. Use a prying tool to pop out the fender turn signal lamp and push it towards the back of the car to unlock the tab holding the fender lamp.Removing the fender light bulb of the Mitsubishi Mirage.Pushing the light bulb backwards to unlock the tab.

    This is the direction where to push the fender light bulb.

  3. Remove the fender turn signal lamp. Press on the clip and pull it out to detach the connector to the fender turn signal lamp.

    Removing the fender light to the connector.
  4. Insert the new fender turn signal lamp to the connector. Connecting the new fender light bulb.
  5. Push the new fender turn signal lamp in back to the fender.Installing the new fender light to the Mitsubishi Mirage.
  6. Turn the signal light of your vehicle on and check the fender turn signal lamp.

Comments

Add new comment

Plain text

Notes

  • Do not touch light bulbs with bare hands as that can shorten the life of the light bulb. 
  • Installing LED bulbs:
    • If you are upgrading to LED light bulbs, and the bulb doesn't turn on when you install it simply remove the LED bulb and rotate it 180 degrees and reinstall it. 
    • Certain vehicles may trigger a fault message stating faulty or burned light bulb when the original bulb has been upgraded to LED. If that is the case, use halogen bulb or get an Error Free LED bulb
Fender Turn Signal Light Bulb Replacement Mitsubishi Mirage This guide provides instructions on how to change the fender turn signal light bulb of the Mitsubishi Mirage.