Front Bumper Replacement Mitsubishi Mirage

What you will need

• Pushpin Plier
• 10mm Socket wrench

Procedure

1. Open the hood. Go to the driver's seat and pull the hood release under the dashboard. Next, go to the front of the vehicle and unlock the hood latch. Pull the hood up and use the support rod to hold the hood up.

    

2. Remove all the push pins holding on to the front bumper, located on the fender and below the front bumper. Use a pushpin plier to easily remove the push pins. There is a total of six push pins on the passenger side and driver side fender and several pushpins below the front bumper.

   These are the location of the push pins on the fender.

   

3. Remove the size 12mm bolts located below the front bumper using a wrench or a socket wrench. There will be a total of two bolts to be removed on the edges below the front bumper.

   
4. Using a socket wrench, remove the four 10mm bolts on the bumper bracket.
5. Remove two bolts that go through the lower grill. 
6. Pop out the edges of the front bumper by pulling it out.
7. Remove the front bumper from the vehicle.
8. Install the new bumper in reverse order. Make sure that all the push pins and bolts you removed are installed.