Hyundai Motor Mount Replacement Instructions

In this tutorial, we will show you how to replace the engine mount (motor mount) on Hyundai vehicles. The pictures and videos in this tutorial are from a 2015 Hyundai Elantra but these instructions apply to most Hyundai vehicles with a four-cylinder engine. Owners of Hyundai Tucson, Accent, Santa Fe, Sonata, Genesis, Veloster, Azera, Equus will find these instructions helpful.

What you will need

Tools Required

Parts Required


Remove engine under shield

You will need to support the engine from underneath. In order to do so, first remove the plastic cover located under the engine. It is not necessary to jack up the car, but if may do so if you find that more practical. how to change replace hyundai engine mount yourselfThis is a picture of under cover located right below the engine. It is also called the lower splash guard. It is held in place with several 10 mm motor mount diy replacement instructionsOnce you remove the bolts, the cover can be lowered and removed. 

Support engine underneath

Use a floor jack to support the vehicle. If you have a small jack don't place it directly under the oil pan or the engine but use a wood block to place between the jack and the engine. Be careful with this step because you can easily damage the lower part of the engine. As you see in the following picture we used a Powerbuilt Heavy Duty Triple lift Car / Motorcycle / ATV 4000 LBS Jack which is perfect for this motor mount how to replace, cost

Remove motor mount

You will need to remove the bolts that secure the motor mount to the engine. Next, you will need to remove bolts that hold the motor mount to your car frame. If the engine starts to lower as you loosen the motor mount to engine bolts make sure to slightly raise the engine using the jack underneath. Otherwise, you risk putting to much stress on the engine hoses and lines and can make them break. 

Replace Hyundai motor mount

Install the engine mount. Make sure that the holes on the motor mount align with the bolt holes on the engine and the car frame. If they don't, you may need to jack up or lower the engine until you can see the holes. Start threading the bolts by hand. Be careful tightening the bolts to the engine. Do not over tighten these bolts or you risk striping the threads. Tighten the bolts to recommended torque specifications. 

Tighten to specs

Tighten bolts to 50 N.m. You may want to use medium strength thread locker (Permatex Medium Strenth Threadlocker) on the motor mount bolts to ensure that they don't get loose due to engine vibrations. 

Motor Mount Replacement Cost

If you have the dealer replace the motor mount expect to pay between $300-$600 to change the motor mount on your Hyundai. Some auto mechanics will change the motor mounts for less. Typically between $250 and $400. 

Replacing the motor mounts on Hyundai may sound difficult but in reality is a very simple task, especially on the four-cylinder engines. Changing the motor mount on Hyundai can be completed by a DIY auto mechanic. You don't need a lift to change the engine mount. You will need to support the engine from underneath. 

Common Symptoms

  1. Engine Vibration
    The most common symptoms of a bad motor mount on Hyundai vehicles is excessive engine vibrations. Excessive cabin vibrations can be noticed when stopped at a light. Typically you will feel vibrations through the car seat, on your steering wheel, and inside the cabin. Constant vibrations are felt inside the cabin when driving on the highway at 60 or 70 mph. 
  2. Excessive Engine Movement
    Worn Hyundai engine mounts allow the engine to move or shake more than designed. You will notice this most when you change gears as a worn engine mount will cause the car to feel a bang/hit when gears are changed. 
  3. Engine Misalignment
    The engine may be lower on the side of the failed engine mount. 
  4. Broken Belts and Hoses
    Due to the engine lowering or moving move that it should you may have problems with A/C lines or other hoses breaking too frequently. 

Where to buy Hyundai Motor Mounts

 Replacement motor mounts for Hyundai can be purchased on many sites online. Take a look at these listing that we found on Amazon. Motor mounts for certain Hyundai vehicles sell for as little as $20 USD.

Check Price:  Hyundai Motor Mount 

Frequently Asked Questions

Yes. Replacing the motor mount on Hyundai vehicles is easy and can be completed at home. You don't need a lift to replace an engine / motor mount.

You will typically know because your car will have constant vibration. The vibrations will be felt on your seat, steering wheel and cabin. Vibrations are felt the most when the car is parked, in drive or at a stop light.

Yes, it is possible that a bad motor mount can cause you to think that the transmission is not shifting smoothly. That's because once the motor mount wear or fails, it will allow the engine to move excessively when the transmission shifts gears.

Yes, you should always support the engine in order to relieve pressure from the hoses, wires and the other two motor mounts. You don't need to raise the engine more than half an inch or so.

Replacing the engine mount on a Hyundai can be completed at home. As you will see in the video clips provided, a professional should be able to change the motor mount in less than one hour. If you are a DIYer or this is the first time you are replacing the engine mount on your Hyundai, plan on a couple of hours. It is important that you accurately diagnose a bad motor mount before you start replacing car parts. Before we jump to the Hyundai motor mount replacement instructions let's go over possible symptoms of bad engine/motor mounts. 


With the car in park, set the parking brake, then depress brake pedal, shift to neutral and feel vibration in neutral as well as in park (should be about the same).  Then, with foot still on brake, shift into drive and if you get a not-so-nice vibration, it is likely the engine and/or transmission mounts.  Beware, some shops charge a lot of money for this job, but most are reasonable.  I will do mine as I enjoy the work.  My victim, I mean my car, is a 2007 Hyundai SantaFe GLS with the 2.7L 6 cyl. engine.  I'll post results and maybe a video of the procedure.  I'm planning 1/2 day, moderate difficulty.  Extra time is for safety concerns ( I like my fingers! ).

Elizabeth, 2019-04-05

A great video gives me an idea of whats the problem and how easy and cheap can be fixed. Thank you

Joe M., 2019-05-09

How do you replace the transmission mount?

Steven S, 2019-07-10

How many motor mounts does the Hyundai Elantra 2013 have ? I saw you did a passenger side motor mount. I saw your video for the motor mount underneath the car. Are there any more motor mounts I should be aware of. My car makes a clunk noise when I go from park to drive or reverse. Just need to know how many I need to check. Thank you very much for the info !!

By YOUCANIC on Apr 5, 2019


Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.