How to jump start Mazda 5 2010-2018

Is Mazda 5 battery dead? In this guide, you will learn how to jump-start a 2010-2018 Mazda 5 vans.

To jump-start a Mazda5 you will need a jump box or you can use jumper cables and another car. Either method is acceptable to jump start your Mazda 5 dead battery. When you jump start a Mazda5, it is important to identify the positive and negative terminals correctly.

What you will need

How to jump-start a Mazda 5

To safely jump start your Mazda 5 follow these instructions. Ensure that keys are removed from the ignition when you connect the cables. 

Turn off ignition

Remove key from ignition of your Mazda. Modern Mazdas are very sensitive to voltage, and Mazda 5 is no exception. To avoid electrical problems, make sure to remove the key from the ignition.

how to jump start Mazda 5 2010 2011 2012 2013 2014 2015 2016 2017 2018

Open Hood

Open the hood. Locate the hood release underneath the dash. Pull the lever until you hear your Mazda hood pop open. Next, you need to release the hood safety latch at the front of the car.

Locate Jump Start Terminals

Locate the battery terminals. Determine where you will jump start your Mazda 5.

Connect Postive Jumper Cable

Attach the red (positive) cable to the positive terminal. If you are using another car to jump start your Mazda 5, next you will need to connect the positive terminal on the helper car.

instruction on how to jump start Mazda 5 with dead battery

Connect Neg. Jumper Cable

Connect the black (negative) cable to an engine ground point. If you are using another car to jump start your Mazda 5, connect the other end of the black cable to the battery of the helper car. 

how to jump start 5 with jumper cables

Jump Start Mazda 5

If you are using a jump box you are now ready to start your Mazda 5. If you are using a helper car continue to the next step.

Jump start 5 using a jump box battery

Just Start Using Jumper Cables

Start the helper car and let it run for about five minutes.  Next, start your Mazda 5. If all you hear is a click when you try to start your Mazda 5, check the cable clamps. Allow the dead battery on your Mazda 5 to charge for a little bit longer then try again.

These instructions apply to Mazda5 made during these years: 2010 2011 2012 2013 2014 2015 2016 2017 2018 

Vehicle

Feedback

💡 Help us improve this article by providing feedback. No registration is required. 

Need Help?

💭 Ask car questions in our Car Forum.

Add new comment