Lower Motor Mount Replacement Hyundai Elantra 2011-2016

In this tutorial, you will learn how to replace the lower motor mount on Hyundai Elantra model years 2011, 2012, 2013, 2014, 2015, 2016. This is also called "ROLL STOPPER." In some cases, this may also be called transmission mount.

Symptoms

  • A bad lower motor mount can cause your car to bang into gear during gear changes.
  • A bad Hyundai lower motor mount can cause noises and also excessive vibrations inside the cabin.

What you will need

Tools Needed

Instructions

Replacing the lower motor mount yourself is easy and should take less than one hour.  Replacing the lower motor mount at a repair shop can cost you between $300 and $450. If you change the motor mount yourself, you will spend about $100 for parts. Need a Hyundai replacement motor mount? 

  1. Park vehicle on a level surface. Turn ignition off and set shifter into Park position. Remove key from the ignition. 
  2. Jack up the car. Since you will be doing this job at home, it is easier to use ramps.diy bottom engine mount replacement hyundai elantra 2011 2012 2013 If you don't have ramps make sure to use car jack but also jack stands. Always secure the car with jack stands. Jacks alone is not enough to ensure that the car won't fall. 
  3. Remove the undercover. It is held in place with several screws. Next, identify the lower motor mount. Located toward the back of the engine. remove install guide diy bottom rear mount hyundai elantra
  4. For this task, you will need a second jack. Ideally, this should be a larger jack. You will need to place this jack under the engine to support it while you remove the motor mount. Support the engine with the second jack. Use a piece of wood between the jack and the engine. This will protect the oil pan from damage. how much to change trasnsmission mount hyundai elantra 2011-2016
  5. Remove two 13mm bolts that secure the lower motor mount. trans motor mount replacement hyundai elantra
  6. Remove the 16 mm bolt.how to replace hyundai elantra motor mount lower If the bolt starts to spin hold the back nut with a wrench.  lower transmission roll stopper replacement hyundai elantra
  7. Reinstall the new motor mount in reverse order. Tighten the mounting bolts to 80 lb-ft.  

Replacement Hyundai Elantra Motor Mount 

  • Hyundai Manufacturer Part Number: EMTA71020
  • Interchange Part Number:A71020, 7066, 71020
  • Placement on Vehicle: Front, Lower
  • Other Part Number:21950-1R000
    Vehicle Information
  • 2011 - 2016 Hyundai Elantra 1.8L 

  • 2010 - 2011 Kia Soul 2.0L

By YOUCANIC on Apr 9, 2019

Vehicle

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.