Mercedes-Benz S400 Hybrid Put Transmission in Neutral

What you will need

• Jumper cables (requires a running car)
• Jumpstarter

Procedure

1. If the vehicle is parked on the inclined ground, place wheel chocks or blocks on the wheel to prevent it from rolling off and causing accidents/injuries.
2. Pull the hood release or the red lever below the dashboard and go to the vehicle's front.
3. Raise the hood a little bit and a pull lever will pop out on the grille.
4. Pull the lever and raise the hood. The hood will automatically go up and set the hood struts in the hold position.
5. Locate the cover of the battery on the passenger side of the engine compartment.

    

6. Remove the cover by removing the clips and pulling the cover out. On many models, you don't need to remove any cover. Just look for a RED plastic piece with the symbol (+) on top. 

    

   
7. Remove the small black cover by the small fuse box, next to the hybrid battery.

    

8. Connect the red jumper cable to the positive terminal of the battery.

    

   
9. Connect the black jumper cable to the ground terminal of the vehicle.

    

10. If you have a start push button, pull the push start button out.

     

11. Insert the key fob into the ignition switch.

     

12. Press the brakes hard and turn on the ignition.

     

13. Push the gear shift toggle up to set it to reverse.

     

14. Pull the toggle down to set it neutral position.

     

    
15. Release the parking brake by pulling the parking brake lever.

     

16. The vehicle is now ready to be pushed or towed. Be careful when you release the PARKing brake as the vehicle may roll off.