Skip to main content

Mitsubishi 2.4L Engine Oil Change DIY

This guide provides instructions on how to change the engine oil on a Mitsubishi.

Mitsubishi 2.4L Engine Oil Change DIY
ESTIMATED TIME 1-2 hours
DIY COST $15-$45
DIFFICULTY Easy

What you will need

Procedure

  1. Drive your Mitsubishi up on car ramps.
     
  2. Place the car in park, and apply the handbrake. Chock the rear tires to prevent vehicle from rolling back. 
    put volvo in park ready to change engine oil
  3. Secure your Mitsubishi with jack stands placed under the lifting points or a structural member.jack up mitsubishi to change engine  oil
  4. Open the hood by pulling the hood release under the dash. open mitsubishi hood to change engine oil
  5. Use the prop road to support the hood.
    open hood mitsubishi
  6. If your Mitsubishi has a splash shield, remove the 10mm bolts.remove mitsubishi lancer outalnder shield to change oil filter It is held in place with several  10mm bolts depending on the model year.mitsubishi splash shield
  7. Place a drain pan directly under the oil pan.
    oil drian pan
  8. Locate the 17mm oil drain plug.
    oil drain pan
    Remove the oil drain plug by turning it counter-clockwise.
    mitsubishi oil drian plug
  9. Locate the engine oil filter and remove it. You can use oil filter pliers or an oil socketsoil filter and remove it. You can use oil filter pliers or an oil sockets.
    remove mitsubishi oil filter

    Install a new oil filter.

    install new mitsubishi oil filter

    Before installing a new oil filter, apply a small amount of oil to the oil filter gasket ring. Get the oil filter as tight as you can by hand.

  10. Replace the copper washer on the oil drain plug.
     
  11. When all of the oil has drained, reinstall the oil drain plug. Torque the drain plug to 35 Nm.
  12. Add approximately four liters of engine oil to the oil fill hole on top of the engine.
    ADD MITSUBISHI ENGINE OIL
  13. Wait for several minutes before checking the oil level using a dipstick. If necessary, add oil to bring the level between the Min and Max marks of the dipstick.
    check volvo engine oil level
  14. Start the engine and check if the oil pressure light goes off within five seconds.
    start mitsubishi engine

Oil Change Interval

12000 km / 7500 miles

You may be wondering how often you need to change the engine oil on a Mitsubishi. The oil change range varies depending on the engine and oil type.

Conventional Oil

  • Every 3000 miles

Semi-synthetic / Synthetic Blend

  • Every 5000 miles

Full Synthetic

  • Every 7500 miles

Oil Capacity

You will need:.

2.0 L Engine

  • 4 L oil pan + 0.3 L oil filter

2.4 L Engine

  • 4.3 L oil pan + 0.3 L oil filter

Check your owner's manual to get the recommended oil change interval for your Mitsubishi.

Torque Specifications

  • Drain bolt - 35 Nm

Instructions in this guide will help you change the engine oil on Mitsubishi Lancer, Outlander, Eclipse, Mirage, Galant.

Comments

Add new comment

Plain text

Notes

Safety Tips

Auto Repair Safety Notes

 

Mitsubishi 2.4L Engine Oil Change DIY This guide provides instructions on how to change the engine oil on a Mitsubishi.