| › BMW

How to replace BMW Cruise Control Switch Stalk Arm

In this guide, you will find instructions on how to replace the cruise control switch on a BMW.

If your cruise control has stopped working the problem could be the switch itself. Before you replace any parts, diagnose BMW cruise control problems by reading the fault codes first.

What you will need

Instructions

Step 1

Disconnect the battery negative terminal.

Step 2

Remove airbag from driver's steering wheel. Detailed instructions on how to replace BMW airbag and steering wheel can be found here.

Step 3

Remove the steering wheel.

Step 4

Pull up the plastic trim cover away to access the cruise control switch. 

bmw cruise control switch diy removal replacement guide

Step 5

Remove two Torx screws that hold the cruise control stalk arm on the steering column switch unit.

bmw cruise control switch replacement diy

Reinstall in reverse order. If the steering wheel isn't reinstalled in the same exact location, you may need to carry out steering angle sensor calibration. 

By YOUCANIC on Aug 6, 2019

Vehicle

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.