How to reset Chrysler Crossfire Oil Service Reminder

Follow these instructions to manually reset the Service Remind (FSS System) on a Chrysler Crossfire 2004, 2005, 2006, 2007,2008.

This method will reset the service light. You should perform this reset after an oil change on your Chrysler Crossfire.

Resetting Service Reminder FSS - Chrysler Crossfire

  1. Turn key to ON/ RUN position.

  2. Within one second press the knob/button twice.

  3. The present status for days or distance is displayed. Within 10 seconds turn the key to OFF / LOCK.

  4. Press and hold the knob/button, while turning the key to ON/RUN again. The present status for days or distance is displayed once more. Continue to hold the knob/button.

  5. After approximately 10 seconds, a signal sounds and the display shows 10,000 miles.

  6. Release the knob/button.

That is the procedure on how to reset oil service light Chrysler Crossfire. 

By YOUCANIC on May 12, 2019

Vehicle

Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.