ESTIMATED TIME 10 - 15 mins
DIY COST $ 20 - 40
DIFFICULTY Very Easy
What you will need
Procedure
- Open the hood by pulling the hood release under the dashboard. Go to the front, unlock the hood latch and pull the hood up.
- Locate the low beam light behind the headlight assembly.
- Disconnect the electrical connector of the low beam light by pressing the clip and pulling it out.
- Twist the low beam light bulb counterclockwise.
- Pull out the light bulb from the headlight assembly.
- Get the new light bulb ready.
- Insert it into the headlight assembly, then twist it clockwise to lock it in its place.
- Reconnect the connector by pushing it back onto the light bulb.
- Check the low beam light by switching it on.
Notes
- Do not touch light bulbs with bare hands as that can shorten the life of the light bulb.
- Installing LED bulbs:
- If you are upgrading to LED light bulbs, and the bulb doesn't turn on when you install it simply remove the LED bulb and rotate it 180 degrees and reinstall it.
- Certain vehicles may trigger a fault message stating faulty or burned light bulb when the original bulb has been upgraded to LED. If that is the case, use halogen bulb or get an Error Free LED bulb.
Comments
Add new comment