
ESTIMATED TIME 30 - 40 mins
DIY COST $ 30 - 100
DIFFICULTY Intermediate
What you will need
Procedure
- Line up the window regulator by holding it closed together and inserting it into its original position.
- Install and tighten the four 10mm bolts on the right side of the window regulator to keep it in place.
- Set the upper arm of the regulator on its proper orientation and install the two 10mm bolt on the center part of the door. Use a 10mm socket wrench and twist it clockwise to tighten the bolts.
- Push the connector of the window regulator into the connection port.
- Reinstall the window glass back to the door by lining it on the glide and install the 10mm bolts below the window.
- Put some adhesive on the edges of the plastic cover to seal it back to the door.
- Put the door panel back to the door.
Comments
Add new comment