At a Glance

  • What it means: the SRS control module found a fault and your airbag system “does not have full functionality,” in Volvo’s words. Some or all airbags and belt pretensioners may not work in a crash.
  • What Volvo says to do: contact an authorized Volvo workshop immediately. You can drive there, but treat the airbags as unreliable until it is fixed.
  • Most common causes: a loose or dirty connector under a front seat, a seat belt buckle or pretensioner fault, the passenger seat occupant sensor, the clockspring in the steering wheel, an impact sensor, low voltage, or crash data stored after an accident.
  • Check recalls first: Volvo has recalled harnesses under the seats, a water leak that can affect airbags, belt anchors and driver airbag inflators. The list is below.
  • Never probe airbag wiring with a test light or meter, and never try to repair airbag parts yourself.
Troubleshooting Volvo Srs Airbag Light Stays On

What the Warning Means

Volvo’s manual explains that the airbag symbol should go out about 6 seconds after you switch on. If it stays on, or comes on while driving, the system has found a fault in the seat belt tensioners, side airbags (SIPS), curtain airbags (IC) or another part of the restraint system. If the symbol itself fails, the warning triangle lights and the display shows “SRS airbag Service required” or “SRS airbag Service urgent.” Volvo manual.

If the passenger seat occupant sensor (OWS) is at fault, the display can show “Pass. Airbag OFF Service urgent,” and Volvo says the passenger front airbag will not deploy in a collision. Volvo OWS page. If PASSENGER AIRBAG OFF lights with an adult in the seat but there is no service message, that is a classification limit, not a fault: have the passenger sit upright for a couple of minutes after a restart, or move them to the rear seat.

Volvo Srs Airbag Service Urgent Drive To Workshop 1 - Volvo Srs Airbag Service Urgent Drive To Workshop: What It Means &Amp; How To Fix It

Common Causes, With the Evidence

1. Connectors and harnesses under the front seats

This is the cause with the strongest documentation. Recall 12V075 covered 32,552 2012 S60, S80, XC60 and XC70 cars whose under seat harness could disconnect when the seat was adjusted, leaving the front and side airbags and the belt pretensioner unable to deploy properly. Recall 15V342 covered 2016 XC90s whose side airbag harness was pinched in the seat; Volvo’s own filing shows the exact message “SRS Airbag Service Urgent, Drive to workshop.” 12V075, 15V342.

Outside those recalls, owners regularly report clearing the fault by reconnecting or cleaning a dirty connector under a seat. Disconnect the battery and wait before touching any yellow SRS connector (procedure below).

Volvo Seat Mat Sensor

2. Seat belt buckles and pretensioners

The buckle tells the SRS module whether the belt is fastened, and the pretensioner is part of the restraint system itself. Volvo recalled loose passenger buckle studs on 74,027 2016 to 2017 cars (16V798) and front belt anchor cables on 308,260 cars from 2007 to 2018 (20V378). After a crash, Volvo’s repair policy is to replace every pretensioner that fired and the buckle that belongs to it. Volvo repair policy via I-CAR.

Volvo Seat Belt Buckle Triggers Airbag Light

3. Passenger seat occupant sensor (OWS)

The weight sensor in the passenger seat decides whether the passenger airbag can deploy. Volvo says never to open, remove or repair OWS parts yourself, and not to put objects under or against the passenger seat. Objects stuffed under the seat and a disturbed connector there are common triggers.

4. Clockspring in the steering wheel

The clockspring carries the driver airbag circuit while the wheel turns. If the horn or steering wheel buttons stop working at the same time as the SRS warning, the clockspring is a strong suspect, though we found that pattern in owner reports rather than a Volvo bulletin. Replacement means removing the driver airbag; leave that to a shop unless you have done SRS work before.

5. Impact sensors

Front impact sensors sit behind the headlights on many models, and side sensors in the doors and pillars. Owners report faults such as SRS-0218 (front left impact sensor) traced to a failed sensor or corroded connector. After a curtain airbag deploys, Volvo requires the pillar collision sensors to be replaced. Volvo policy via I-CAR.

6. Low voltage, jump starts and electrical work

Volvos are known among owners for logging misleading faults when voltage drops, after a jump start or when a module is unplugged with the ignition on. Disconnecting the radio, a seat or any SRS part without first disconnecting the battery can set a stored fault that stays until it is cleared with a capable scan tool.

Volvo Sras Light On Due To Disconnecting Radio Stereo
Jump Starting Volvo Triggers The Srs Airbag Light

7. Previous accident and crash data

After a crash, the SRS module stores crash data. Volvo’s policy is that the module must be replaced if its codes cannot be erased, if it is damaged, or if the floor around it is damaged, and rear pretensioners fire with any airbag deployment. Independent module repair and crash data reset services exist; for module level repair, see Module Medics. Any reset module must still be coded to the car, or it will set new faults.

Volvo Reseting Crash Data After Accident

8. Water in the cabin

Recall 16V690 covered 43,766 2016 to 2017 XC90 and S90 cars with a misinstalled A/C drain hose that could leak water inside and affect airbag deployment. 16V690. On any Volvo, a wet carpet near the seats or center console deserves a look when this warning appears.

9. Plug in hybrids

On Twin Engine plug in hybrids, Volvo Technical Journal 34567 describes code SRS-B15381B (“High voltage battery loop control”) triggering the SRS message; the fix is checking the wiring at the high voltage battery’s low voltage connector. Volvo TJ.

Volvo Dim Problem Triggers Srs Airbag Light Xc70, V70, S60, S40, V40, V50, Xc60, Xc90, S60, S70, S80, C30 240

A failing instrument cluster (DIM) can also cause warning and display problems on older models. See our guide to Volvo instrument cluster problems.

Volvo Airbag and Restraint Recalls

NHTSA IDVehiclesUnitsProblemRemedy
20V6812001 to 2003 S60, S80 sold in hot, humid states54,124Driver airbag inflator can ruptureNew driver airbag
21V7662001 to 2009 S60, 2001 to 2006 S80259,383Driver airbag inflator can ruptureNew driver airbag
21V8002001 to 2007 V70, XC70194,546Driver airbag inflator can ruptureNew driver airbag
12V0752012 S60, S80, XC60, XC7032,552Under seat harness can disconnectSecure harness
15V3422016 XC90584Side airbag harness pinched in seatReroute and sleeve
15V4972016 XC903,911Third row curtain may not fully inflateModify trim panels
16V6902016 to 2017 XC90, S9043,766Water leak may affect airbagsInspect or replace drain hose
16V7982016 to 2017 XC90, S90, XC60, V60, S6074,027Passenger buckle stud may loosenInspect, replace buckle
17V1042017 XC90, S90, V90CC10,476Curtain airbag bolts may breakReplace bolts
20V3782007 to 2018 S80, S60, V60, V70, XC70, XC60 and others308,260Front belt anchor cable may fatigueReplace cables
23V8272015 to 2024 XC902,911Second row buckle and anchor bolts looseTighten

Source: NHTSA recall records. The older driver inflator recalls involve ZF/TRW inflators; Volvo cars were not part of the Takata or ARC inflator recalls. Run your VIN at nhtsa.gov/recalls before paying for any SRS repair.

How to Read and Clear the Fault

  1. Read the codes from the SRS module with a scan tool that supports Volvo SRS. Older Volvos store codes like SRS-0218; newer ones use a longer format like SRS-B15381B. The description names the circuit.
  2. Fix the cause before clearing. A code that returns immediately is still a live fault.
  3. Clear the codes and confirm the light goes out about 6 seconds after switching on.
  4. If a crash code will not clear, the module needs replacement or a professional reset and coding. Disconnecting the battery does not clear SRS faults.

Working Safely Around Airbags

  • Disconnect the negative battery cable, and the auxiliary battery if your car has one, before touching any SRS connector. Volvo procedures call for waiting at least 3 minutes on a 2008 S40 and at least 30 seconds on a 2016 S60 after depowering. Check the procedure for your car. S40 procedure, S60 procedure.
  • Never put a test light or multimeter on airbag or impact sensor circuits. Diagnose with the scan tool.
  • Never try to open or repair an airbag, pretensioner or OWS part.
  • Store a removed airbag face up, away from heat.

What Parts Cost

PartPart numberPrice
Clockspring (genuine), S60, V60, S80, XC60, XC7031343218 / 31343662$332.99
Clockspring (genuine), C30, C70, S40, V5031264801$294.99
Front impact sensor, C30, S40, S80, V50, XC6031264410$179.99
Impact sensor, XC90 (2016 on), XC60, S90, V9031451531$230.99
SRS control module, XC90 (2003 to 2014)31295112$734.99
SRS control module, XC90, XC60, S90, V90 (2016 on)32315584$1,026.99
Front buckle, 2011 and later S6031436952$160.30

Prices from FCP Euro and Volvo parts in October 2026. Confirm fitment by VIN. Labor varies widely, and some of these parts must be coded with Volvo software after fitting.

Is It Legal to Drive?

Federal law stops repair shops from knowingly disabling airbags, but there is no federal rule banning you from driving with the light on. State inspection rules vary: in Maryland, for example, a lit airbag light is noted on the inspection report but is not a reason to fail. MSP bulletin. Legal is not the same as safe; get it fixed promptly.

When to Stop and Hand It Over

  • The car has been in a collision or any airbag or pretensioner has fired.
  • The fault points to an airbag, the clockspring or a pretensioner.
  • A crash code will not clear.
  • Your car is under one of the recalls above.

Finding the Real Cause

The YOUCANIC Full System Scanner reads Volvo SRS codes so you know which circuit failed before you start pulling trim, and shows whether the fault is current or stored.

Read it, do not probe it, and when you need no tool

One safety point outranks everything else on this page. Do not test, probe or backprobe airbag circuits to chase this message. Supplemental restraint circuits can deploy a component while you are working on them, and the correct way to find out what is wrong is to read the stored code rather than put a meter on the wiring.

That reading is the one step here that needs a tool capable of talking to the restraint module, which a basic engine reader cannot do. If you need it once, rent one for seven days or have the code read at a shop. And if the message appeared immediately after work on a seat, a belt or a connector under a seat, that is where to look first, and often the fix is a reconnected plug rather than any part at all.

Experts Who Contributed to This Article

Elbert Nonog

Elbert Nonog, Automotive National Cert., BS Mechanical Eng.

Diagnostic Specialist13+ years of experience

Elbert G. Nonog is an Automotive Technical Writer and Training Manager with over 10 years of experience across major brands including Chevy, MG, Ford, Volkswagen, and Toyota. Rising from technician to leadership roles, Elbert excels at transforming complex automotive concepts into accessible training materials and documentation. His expertise spans conventional and electric vehicle systems, nationwide dealership training, and aftersales operations management. With TESDA certification and pursuing further education from the Technological University of Philippines, Elbert effectively bridges the gap between automotive engineering and practical application for industry professionals and enthusiasts.

rhila

rhila, ASE Certified

Diagnostic Specialist15+ years of experience

Rushit Hila is a dedicated automotive engineer with ASE G1 certification and specialized training from an esteemed Automotive Specialty School. His hands-on experience and technical expertise in advanced diagnostics, system integration, and performance optimization make him a trusted voice in the industry.