How to Check Fuses on a Car
About this video
Buy YOUCANIC Pro Scanner
Get Factory Service Repair Manuals & Specs
Ask Car Questions & Get Help
https://www.youcanic.com/forum/ Testing fuses in a car is a fairly simple process that can be accomplished with a multimeter or a test light. It’s important to ensure your safety first by turning off the vehicle and removing the keys from the ignition. Here are the general steps:
Using a Multimeter:
Locate the fuse box: The fuse box is usually located under the dashboard on the driver’s side, in the engine compartment, or in the trunk. Check your car’s manual if you’re having trouble finding it.
Remove the fuse: Carefully remove the fuse you want to check using a fuse puller (which is often included in the fuse box) or a pair of needle nose pliers.
Set up the multimeter: Turn the multimeter to the ohms setting (Ω) for continuity check.
Check the fuse: Touch one probe to one end of the fuse, and the other probe to the opposite end. If the multimeter reads close to zero (or shows continuity), the fuse is good. If the multimeter reads ‘1’ or ‘OL’ (over limit), it means there’s no continuity, indicating the fuse is blown.
Replace the fuse: If the fuse is blown, replace it with a new one of the exact same rating. Never use a fuse with a higher rating as this can cause a fire.
Using a Test Light:
Locate the fuse box: As above.
Ground the test light: Connect the clip or clamp on the test light to any good ground on the car (usually the metal frame).
Test the fuse: Touch the probe of the test light to both ends of the fuse. If the test light illuminates on both ends, the fuse is good. If it only illuminates on one end, the fuse is blown.
Replace the fuse: If the fuse is blown, replace it with a new one of the same rating.
In both cases, if a fuse blows immediately after being replaced, this is usually an indication of a more serious electrical problem and professional help should be sought. Also remember to place the fuse box cover back on once you’re done testing the fuses.