Do you hear a scratching sound when turning on your wiper, or are the wipers leaving streaks on the windshield? Learn how to replace Acura wiper blades.
What you will need
SaleBestseller No. 1
- Windshield Washer Blades
- Park the ACURA on a level surface. Remember to set the parking brakes and remove the key from the ignition.
- Determine which wiper blade you are going to change first. Move the wiper blade up. Be careful, and do not let the wiper arm fall on the windshield.
- Use a small flat screwdriver to lift the plastic clip that locks the wiper in place. Not all ACURA wipers have this plastic clip. If yours doesn’t, continue to the next step.
- Rotate the wiper slightly so that you can press the wiper release.
- Press the release tab and pull down the windshield wiper, as shown in this picture.
- Grab the new wiper. Be extremely careful, so the wiper arm doesn’t fall on your ACURA glass. If the wiper arm drops on the glass, it can crack the windshield.
- Slide the new wiper into the wiper arm until you hear it click.
- Lastly, follow the same procedure to change the other wiper blade.
ACURA Wiper Size
The driver-side wiper blade on Acura is standard. Acura uses a 26-inch wiper on the driver’s side. The passenger side wiper varies between models. See the table below for details.
Driver Wiper Blade Size
- 26 Wiper Blade
- Most common on many Acura models.
Passenger Wiper Blade Size
Rear Wiper Blade Size
- Acura rear wiper blade size is 14 inches (typical).
Always verify with the dealer or the seller whether the wipers you buy will fit your Acura. Alternatively, look up the correct Acura wiper blade size on your owner’s manual or look it up online using a Wiper Blade Size Lookup tool.
We hope you find the Acura Windshield Wiper Blade Replacement DIY guide helpful. Check these troubleshooting and repair guides for more help on your Acura.
Have questions about your car? Get assistance in our newly launched forum section. We’re here to provide support!