Chrysler Sebring Change Front Brake Pads
Worn brake pads announce themselves with squealing or grinding, longer stopping distances, a brake pedal that sits lower than it used to and often a wear warning light on the dashboard. What they do not cause is a soft or spongy pedal. If your pedal feels springy, travels further than it should or sinks slowly toward the floor, that is air in the hydraulic system, a fluid leak or a failing master cylinder, and fitting new pads will not fix it. Find that cause before driving the car. If your symptoms are wear related, the procedure below covers the job.
What you will need
- Chrysler Sebring Front Brake Pads
- Jack and Jack Stands
- Flathead screwdriver
- 14mm socket
- Ratchet
- Brake grease
- Torque wrench
Procedure
- With the wheels on the ground, loosen the lug nuts, but don’t remove them.
- Jack up your Chrysler Sebring and secure it with jack stands.
- Remove the front wheel from your Chrysler Sebring.
- Use a flathead screwdriver to press the caliper piston into the caliper.
- Use a 14mm socket to remove one of the guide pins.
- Fold out the brake caliper and remove old brake pads and shims.
- Install the new brake pads. Apply a small amount of grease where the brake pads slide on the brake caliper.
- Install the brake caliper. Apply grease to the guide pins.
- Torque guide pins to 31 Nm or 23 ft-lb.
- Install the wheel and tighten it. Remember to tighten the lug nuts when the vehicle has been lowered to the ground.
- Start your Chrysler Sebring and pump the brake pedal a few times before starting to drive.
Helpful Links
Check these troubleshooting and repair guides for more help on your Chrysler.


