Fix Sun Visor Vanity Light Switch on Mercedes-Benz E-Class
Is your sun visor vanity light switch not working on your Mercedes-Benz? Learn how to fix the problem by replacing the vanity light switch.
At a Glance
- Vehicle: Mercedes-Benz E-Class W211 (2008 E350 shown); similar on other models
- Cause: The mirror cover no longer presses the small switch behind it
- Fix: Glue a small rubber bumper on the switch to make up the gap
- Parts: Small rubber bumpers (such as from an eyeglass repair kit) and glue
- Time: About 15 minutes
- Care: The plastic lid breaks easily, and glue must stay out of the switch
Problem
The Sun visor (vanity) light does not come on even after replacing the light bulb, or the switch for the sun visor light may fail.
Check These First
- Bulb: Swap in a known good bulb, or swap the bulbs between the driver and passenger visors.
- Visor contacts: The visor gets power through the metal contacts at its pivot clip. Make sure the visor is fully clipped in at the inner end.
- Fuse: If both visor lights are out, check the interior lighting fuse listed in your fuse chart.
- Switch contact: If one light works only when you press the small black switch behind the mirror by hand, the switch is good and the lid is not reaching it. The fix below solves that.
Solution
If you have a faulty vanity mirror switch on your Mercedes-Benz W211 chassis or any E-class sedan (mine is a 2008 E350), you can easily fix the switch problem.
🔧 Find out what is actually wrong before you pay someone to guess
Dealer level diagnostics at home with the YOUCANIC UCAN-II Pro.
- ✔ Covers most makes and models, including many luxury brands. Send us your VIN and we will confirm your car before you order
- ✔ Reads every module, not just the engine, so you find the faults a basic reader says are not there
- ✔ Commands the car: test a fan or pump, bleed ABS, retract an electronic parking brake, register a battery
- ✔ No subscriptions. Free lifetime updates, so the price you pay is the whole price
- ✔ Backed by real mechanics in the USA you can email before and after you buy
Featured in The Wall Street Journal
- Flip open the sun visor.

- Remove the mirror along with the plastic trim. Be careful with the lid, as it can easily break.

- I took two small rubber bumpers from the eyeglass repair kit, glued them on top of each other, and then glued them on the little black switch behind the vanity mirror.

- Be careful not to let glue seep into the switch, or it might freeze. This one was on the passenger side of my sedan. It’s a very easy fix, and I hope it works for you!
Check these troubleshooting and repair guides for more help on your Mercedes-Benz.
Frequently Asked Questions
Why does my Mercedes vanity mirror light not turn on?
The most common cause is that the mirror cover no longer presses the small switch behind it. A burnt bulb, poor visor contacts or a blown fuse can also cause it.
Do I need to replace the vanity light switch?
Usually not. If the light works when you press the switch by hand, adding a small rubber shim on the switch fixes it.
How do I remove the vanity mirror on a W211?
Flip the visor open and carefully pry out the mirror with its plastic trim. Go slowly, because the lid breaks easily.
Can glue damage the switch?
Yes. Keep glue on top of the switch only. If it seeps inside, the switch can stick.
Related Guides
- 2015+ Mercedes-Benz C E S Class Tail Light Replacement
- Replace Front Turn Signal Light Bulb Mercedes-Benz GLA-Class 2014 to 2019
- Dome Roof Light Mercedes-Benz 2014 to 2019 GLA-Class X156
- Mercedes-Benz R-Class Low Beam Light Bulb Replacement




