Cadillac Hood Lift Support Replacement DIY

In this guide, you will learn how to replace the hood lift support (gas strut) on Cadillac ATS, CTS, XTS, CT6, XT5, Escalade, SRX, DTS, STS, BLS, XLR.

Changing the hood support on any Cadillac is easy and takes less than half an hour. Follow the instructions or watch the video on how to change Cadillac gas-filled hood support. 

Symptoms 

The hood strut may be the culprit if you are experiencing any of the following problems. 

  • Cadillac hood won't stay up,
  • Hood stays open for a few seconds then closes
  • Hood won’t stay open by itself anymore
  • Hood closes automatically

What you will need

  1. Cadillac Hood Lift Support
  2. Flat Screwdriver,
  3. Helper

Instructions

Step 1

Open the hood of your Cadillac. The hood latch release is located under the dashboard on driver's side.

Step 2

Locate the weak Cadillac  hood strut support

Have a friend hold up the hood of your Cadillac. If the hood falls while you are changing the hood lifts on your Cadillac, you can get seriously injured.

Step 3

hold up Cadillac  hood by hand

Secure the hood in upright position. Locate the hood struts that need to be replaced.

Step 4

Cadillac  hood strut joint

Locate the clip that locks the hood support to the ball joint.

Step 5

detach hood gas strut from Cadillac

Use a flat screwdriver to pry out the clip that locks the hood strut in place.

Step 6

cadillac hood gas strut replacement diy

Follow the same procedure for the other end. Install the new hood support in reverse order.

Step 7

cadillac hood strut

Repeat this procedure for the other hood support, if your Cadillac has two.

Vehicle

Feedback

💡 Help us improve this article by providing feedback. No registration is required. 

Need Help?

💭 Ask car questions in our Car Forum.

Add new comment