Audi › Resources

By YOUCANIC on May 21, 2019

How to change Audi Hood Supports

If your Audi hood does not stay up the problem is often the hood struts, also known as hood lift support, hood shock, gas strut.

In this guide, you will learn how to replace the hood struts on Audi models such as A1 A3 A4 A5 A6 Q3 Q5 Q7. 

Changing Audi hood hydraulic sturts is easy and takes less than half an hour.


The hood strut may be the culprit if you are experiencing any of the following problems. 

  • Audi Hood won't stay up
  • Hood won’t stay open by itself anymore
  • Audi hood will not stay open
  • Audi hood stays open for a few seconds then closes
  • Hood closes automatically

What you will need


Step 1

Open the hood of your Audi. The hood latch release is located under the dashboard on the driver's side.

Step 2

Locate the weak Audi A S Q TT models  hood strut support

Secure the hood in upright position. Locate the hood struts that need to be replaced.

Step 3

hold up Audi A S Q TT models  hood by hand

Audi hood strut is shown on a Q5. Have a friend hold up the hood of your Audi. If the hood falls while you are changing the hood lifts on your car, you can get seriously injured.

Step 4

Audi A S Q TT models  hood strut joint

Locate the clip that locks the hood support locks to the ball joint.

Step 5

detach hood gas strut from Audi A S Q TT models

Use a flat screwdriver to pry out the clip that locks the hood strut in place.

audi hood strut replacement diy

A picture of Audi hood gas strut connecting to the hood. 

audi a4 hoot strut replacement guide diy

Picture of Audi A4 hood strut connecting to the frame. 

Step 6

audi hood strut a4

Follow the same procedure for the other side if your Audi has two hood struts. You may notice that at this point your Audi will stay up with only one new hood strut. Replace both hood struts if your Audi has two hood struts. Otherwise, the new hood strut that you replaced will be doing all the heavy lifting and will wear prematurely. Some Audi models such as the A4 shown above may have only one hydraulic hood support.

Step 7

Install the new hood support in reverse order.

Step 8

Audi A S Q TT models  Hood lift DIY

Repeat this procedure for the other side.


Plain text

  • Allowed HTML tags: <a href hreflang> <em> <strong> <cite> <blockquote cite> <code> <ul type> <ol start type='1 A I'> <li> <dl> <dt> <dd> <h2 id='jump-*'> <h3 id> <h4 id> <h5 id> <h6 id>
  • No HTML tags allowed.
  • Lines and paragraphs break automatically.
  • Only images hosted on this site may be used in <img> tags.