Mazda Check Automatic Transmission Fluid Level

Mazda Check Automatic Transmission Fluid Level

Need to check the transmission fluid of your Mazda? This guide is a step-by-step procedure for checking the transmission fluid level on a Mazda vehicle.


If the Mazda transmission fluid level is low, you may experience shifting problems such as:

  • Transmission slipping
  • Delayed shifting
  • Hard shifting
  • The transmission doesn’t shift
  • Overheated transmission

How to check Mazda automatic transmission fluid level

  1. Warm-up transmission. Drive your vehicle for at least ten minutes. This will allow your Mazda transmission fluid to warm up. If the vehicle does not move or the transmission slips, do not drive or you risk damging the transmission.
  2. Ensure the Mazda is parked on a level surface. Ensure the parking brake is set—shifter in Park. open hood
  3. Do not turn off the engine. Allow the engine to idle. diy instructions on how to add transmission fluid on mamo
  4. Open the hood. Pull the hood release under the dashboard on the driver’s side.
  5. Locate the transmission dipstick at the back of the engine.
  6. While the engine is idling, pull out the dipstick. Clean the dipstick and reinsert it. how to add automatic transmission fluid on Mazda
  7. Pull the dipstick. Make sure that the Mazda transmission fluid level is between the Full and Low-level marks.
  8. If the level is below the minimum mark, add half a quart/litter via the same tube you used to check the level. Only use the recommended Mazda transmission fluid mentioned in your owner’s manual. You will need a funnel for this. Recheck the level.
  9. Recheck the transmission fluid level. Add more automatic transmission fluid if necessary but do not overfill above the Max / Full mark.

The exact procedure for checking your Mazda transmission fluid level is outlined in your owner’s manual. Newer Mazda vehicles often do not have a transmission dipstick. On those models, the transmission fluid level is checked via the fill hole.

How to add automatic transmission fluid to a Mazda

Adding transmission fluid to a Mazda is a simple procedure. Make sure to add the recommended Mazda automatic transmission fluid or a compatible alternative.

  1. Park the Mazda. Set the parking brakes. Move the shifter to the Park position.
  2. Open the hood.
  3. Remove the dipstick. The automatic transmission dipstick is located next to the battery.
  4. Use a funnel to insert it into the dipstick tube.
  5. Add half a quart of Mazda Automatic Transmission Fluid (ATF).
  6. Recheck the fluid level.
  7. If the level is above the Min mark and below the dipstick’s Max mark, you are done. If it is below, add more fluid. If it is above the Max mark, you need to remove the extra fluid or risk injuring the automatic transmission.

Bestseller No. 1

Genuine Mazda (0000-FZ-113E-01) Automatic Transmission Fluid , 32 fl oz


Genuine Mazda (0000-FZ-113E-01) Automatic Transmission Fluid , 32 fl oz


Genuine Mazda 0000-FZ-113E-01 ATF Type-Fz; genuine oem factory part; exact fit; durable; best in quality


Recommended Mazda Transmission Fluid

The most common transmission fluid used in Mazda is Mazda MV ATF. A few alternative transmission fluids that are compatible with Mazda MV ATF are:

  1. AMSOIL Synthetic ATF
  2. Mobil1 Synthetic ATF
  3. Valvoline Maxlife Multi-Vehicle ATF
  4. Schaeffers
  5. REDLINE D4 ATF on eBay
  6. Nippon Oil Eneos ATF Fluid

Always check with your owner’s manual to verify the correct type of transmission fluid used in your Mazda.

Mazda recommends Mazda ATF MV transmission fluid (also referred to as M5 ATF or Mazda V). Mazda MV ATF is not the same as Mercon V or Dexron automatic transmission fluid, a common misconception. Don’t use Mercon or Dexron transmission fluid on a Mazda, or you will start experiencing shifting problems after a few months.

This guide on checking lever and adding automatic transmission fluid on Mazda cars, including Mazda 3, 5, 6, CX5- CX-7, CX-9 Protege, and Tribute.

We hope you find the Mazda Check Automatic Transmission Fluid Level guide helpful. For more help with Mazda vehicles, check out these troubleshooting and repair guides.

Leave a Reply

Your email address will not be published. Required fields are marked *


  1. Anonymous says:

    thanks a lot,guide and information.
    we have a question regarding my old mazda 323 model 1994 glx 16valve dohc engine. what is the compatable ATF fluid?

  2. Anonymous says:

    Klondike synthetic atf in Canada also works