Is the turn signal and wiper switch (combination switch) of your Toyota Camry not working? Learn how to fix the problem by replacing the combination switch of your vehicle. This guide is a step-by-step procedure for replacing the Turn Signal and Wiper Switch (also known as combination switch) on a Toyota Camry XV50 2012-2017.

What you will need

Bestseller No. 1
1A Auto Headlight Turn Signal Combination Switch for 4Runner Avalon Camry Celica Prius
1A Auto Headlight Turn Signal Combination Switch for 4Runner Avalon Camry Celica Prius
Direct Fit, OE Replacement Combination Switch; Vehicle Specific: Check fitment information in the listing for compatibility
$45.34
  • Toyota Camry XV50 Combination Switch
  • Flathead Screwdriver

Procedure

Remove the clock spring. If you need help with this step, follow these procedures to remove the clock spring.

https://youtu.be/s_BfVQpdYqo


Disconnect the electrical connectors of the combination switch by pressing the clip and pulling the connector out.Disconnecting the electrical connectors of the combination switch.


Pull the tab on the wiper switch using a flat screwdriver.Pulling the tab holding the wiper switch.


Remove the wiper switch by pulling it out from the turn signal switch steering column bracket.Removing the wiper switch of the Toyota Camry XV50.

Locate the two clips behind the turn signal switch attached to the steering column.The Location of the two clips behind the turn signal switch.

The two clips on the turn signal switch bracket.


Pull the two clips together using a flat screwdriver to unlock them.Unlocking the two clips on the turn signal switch bracket.

Remove the turn signal switch by pulling it out from the steering column.Pulling the turn signal switch out from the vehicle.

Pulling the turn signal switch out from the vehicle.

Remove the turn signal switch by pulling it out from the steering column.Pulling the turn signal switch out from the vehicle.

Pulling the turn signal switch out from the vehicle.


Line up the new turn signal switch to the steering column and push it to lock it in position.Installing the new turn signal switch of the Toyota Camry XV50.


Place the new wiper switch to the steering column bracket and push it in until it snaps into place.Installing the new wiper switch of the Toyota Camry XV50.


Reinstall the clockspring. If you need help with this step, follow these procedures for the installation process of the clockspring.Reinstalling the clock spring of the Toyota Camry.


Reinstall the steering wheel. If you need help with this step, follow these procedures for the installation process of the steering wheel.Reinstalling the steering wheel of the Toyota Camry.


Reinstall the airbag.  If you need help with this step, follow these procedures for the installation process of the airbag.Reinstalling the airbag of the Toyota Camry.

Airbag SRS Light On

YOUCANIC UCAN2 SCANNER

If the Airbag Light is on after replacing the combination switch, you can use the YOUCANIC Full System Scanner to reset the Airbag Light. This scanner can also read and clear fault codes through every vehicle’s control module.

We hope you find the Toyota Camry Turn Signal & Wiper Switch Replacement guide helpful. Check these troubleshooting and repair guides for more help on your Toyota.

Leave a Reply

Your email address will not be published. Required fields are marked *